Cisco 11503 - CSS Content Services Switch Administration Manual page 176
Content services switch
Hide thumbs
Also See for 11503 - CSS Content Services Switch:
- Configuration manual (250 pages) ,
- Hardware installation manual (184 pages) ,
- Getting started manual (142 pages)
Table of Contents
Advertisement
Frequently Queried Log Messages
Table 4-8
Log Message (sys.log: Subsystem
Name, Level, and Message)
portmapper Subsystem
PORTMAPPER-5: PortUnmap no Port
mapping found.
publish Subsystem
PUBLISH-1: Unable to allocate
tree memory <4150000>
Cisco Content Services Switch Administration Guide
4-56
Cisco 11500 Series CSS Log Messages (continued)
Chapter 4
Using the CSS Logging Features
Cause and Resolution
A source group is running out of
portmappers. Use the portmap
command to increase the portmappers
on the source group so that the message
does not appear, and users or services
do not see a performance or network
address translation problem.
The CSS is looking for a segment of
memory that is approximately 4150000
bytes and it cannot locate an available
block of memory. In some cases, this
message may be caused by a
replication misconfiguration. Review
the configuration and verify that it
reflects what was intended. Verify that
files are being replicated properly.
If this message is seen with
significantly smaller memory requests,
the system memory may not sufficient
in size to meet the requirements of the
configuration. To isolate the issue,
monitor the available memory under
non-replication conditions to
determine a baseline and then repeat
this process while replicating to isolate
this issue.
Use the show system-resources
command to view information about
the installed and free memory in the
CSS. To make additional memory
available, reboot the CSS.
OL-5647-02
Advertisement
Table of Contents
