Configuring An Snmp Community - Cisco 11503 - CSS Content Services Switch Administration Manual
Content services switch
Hide thumbs
Also See for 11503 - CSS Content Services Switch:
- Configuration manual (250 pages) ,
- Hardware installation manual (184 pages) ,
- Getting started manual (142 pages)
Table of Contents
Advertisement
Defining the CSS as an SNMP Agent
Configuring an SNMP Community
Caution
Cisco Content Services Switch Administration Guide
5-14
To set or modify SNMP community names and access privileges, use the snmp
community command. You may specify as many community names as you wish.
You must define the community strings for each access type (read-only or
read-write) before you use SNMP on the CSS. The CSS is inaccessible until you
specify a read community string.
The syntax for this global configuration mode command is:
snmp community community_name [read-only|read-write]
The variables and options for this command are:
community_name - The SNMP community name for this system. Enter an
•
unquoted text string with no space and a maximum of 12 characters.
read-only - Allows read-only access for this community.
•
read-write - Allows read-write access for this community.
•
For example:
(config)# snmp community sqa read-write
To remove a community name, enter:
(config)# no snmp community sqa
Chapter 5
Configuring Simple Network Management Protocol (SNMP)
OL-5647-02
Advertisement
Table of Contents
