Viewing A Traplog File; Viewing A Css Disk Log File - Cisco 11503 - CSS Content Services Switch Administration Manual
Content services switch
Hide thumbs
Also See for 11503 - CSS Content Services Switch:
- Configuration manual (250 pages) ,
- Hardware installation manual (184 pages) ,
- Getting started manual (142 pages)
Table of Contents
Advertisement
Viewing RMON Information
Viewing a Traplog File
Viewing a CSS Disk Log File
Cisco Content Services Switch Administration Guide
6-34
For information on configuring an RMON event, see the
Event"
section. For information on configuring an RMON alarm, see the
"Configuring an RMON Alarm"
A traplog file is an ASCII file in the log directory containing generic and
enterprise SNMP traps. No configuration is necessary for the traplog file. When
an RMON alarm event occurs, a notification of its occurrence is automatically
saved in the trap log file on the CSS. Even when traps are disabled, the CSS still
produces a log message for any event that would normally generate a trap.
When a traplog file reaches its maximum size (50 MB for a hard disk-based CSS,
10 MB for a flash disk-based CSS), the CSS renames the traplog file to
traplog.prev as a backup file and starts a new traplog file. The CSS overwrites the
backup traplog file when it renames the traplog file. Each time the CSS reboots,
it continues to use the existing traplog file until it reaches its maximum size.
The traps sent to the traplog file are the same traps sent to an SNMP network
management station. Refer to
Management Protocol
To display all SNMP traps that have occurred on the CSS, enter:
# show log traplog
Before the CSS can send an event to a log location, you must:
Configure the location by using the logging disk, host, line, or sendmail
•
command.
Enable logging for the network management subsystem. To do so, enter:
•
(config)# logging subsystem netman level info-6
Refer to
Chapter 4, Using the CSS Logging
logging for the CSS.
To view the events in a log file on the CSS disk, use the show log log_filename
command. To view a log file named log1, enter:
# show log log1
Chapter 6
section.
Chapter 5, Configuring Simple Network
(SNMP), for information on configuring SNMP.
Features, for details on configuring
Configuring Remote Monitoring (RMON)
"Configuring an RMON
OL-5647-02
Advertisement
Table of Contents
