Creating An Index For An Rmon Alarm; Modifying The Attributes For An Existing Rmon Alarm Index - Cisco 11503 - CSS Content Services Switch Administration Manual
Content services switch
Hide thumbs
Also See for 11503 - CSS Content Services Switch:
- Configuration manual (250 pages) ,
- Hardware installation manual (184 pages) ,
- Getting started manual (142 pages)
Table of Contents
Advertisement
Configuring an RMON Alarm
Creating an Index for an RMON Alarm
Note
Modifying the Attributes for an Existing RMON Alarm Index
Cisco Content Services Switch Administration Guide
6-14
The RMON alarm index identifies the alarm to the CSS. This index allows you to
assign specific configuration attributes to the RMON alarm. When you create an
RMON alarm index, you access the configuration mode for that alarm
automatically.
Use the rmon-alarm index command to create an alarm index. You can access
this command from any configuration mode except the boot and RMON history
configuration modes. The index is an integer from 1 to 65534.
The RMON alarm index 65535 is administratively predefined and cannot be
modified. If you enter this index number, a message similar to the following
appears:
%% Index internally used. Administrative control not allowed.
To create an RMON alarm with an identifier of 1, access global configuration
mode and enter:
(config)# rmon-alarm 1
To see a list of existing RMON alarm configuration identifiers, enter
rmon-alarm ?.
After you create the identifier for the alarm, the prompt changes to
(
config-rmonalarm[1]
"Setting the RMON Alarm Attributes"
Before you can modify attributes for an active RMON alarm, you must deactivate
the alarm. Use the suspend command to deactivate the RMON alarm and make
attribute changes.
For example:
(config-rmonalarm[1])# suspend
Chapter 6
). Now you can define the alarm as described in the
section.
Configuring Remote Monitoring (RMON)
OL-5647-02
Advertisement
Table of Contents
