Loading The Css Mibs; Snmp Communities - Cisco 11503 - CSS Content Services Switch Administration Manual
Content services switch
Hide thumbs
Also See for 11503 - CSS Content Services Switch:
- Configuration manual (250 pages) ,
- Hardware installation manual (184 pages) ,
- Getting started manual (142 pages)
Table of Contents
Advertisement
Chapter 5
Configuring Simple Network Management Protocol (SNMP)
Loading the CSS MIBs
Note
SNMP Communities
OL-5647-02
We recommend that you update the CSS Enterprise MIBs after you upgrade the
CSS software. CSS MIBs are included in the CSS GZIP file. During the software
upgrade, the MIBs are loaded into the CSS /mibs directory. For details about the
CSS MIBs, see the
"CSS MIBs"
To update the CSS MIBs on your management station after you upgrade the CSS:
Transfer the CSS MIBs using FTP from the CSS MIBs (/v1 or /v2) directory
1.
to your management station.
The CSS implementation of FTP does not support the mget
Note
command, which is used for multiple file transfers.
Load the CSS MIBs into the management application.
2.
The /v2 directory contains the full set of CSS v2 MIBs. The /v1 directory contains
only those CSS v1 MIBs that will compile using a v1 compiler. If you do not find
a MIB that you need in the /v1 directory, use the corresponding MIB in the /v2
directory.
Each SNMP device or member is part of a community. An SNMP community
determines the access rights for each SNMP device.
You supply a name to the community. After that, all SNMP devices that are
assigned to that community as members have the same access rights. The access
rights that the CSS supports are:
read - Allows read-only access to the MIB tree for devices included in this
•
community
read-write - Allows both read and write access to the MIB tree for devices
•
included in this community
section.
Cisco Content Services Switch Administration Guide
SNMP Communities
5-9
Advertisement
Table of Contents
