Table of Contents
Advertisement
ipv6 access-list
ipv6 access-list
Use the ipv6 access-list global configuration command to define an IPv6 access list and to place the
switch in IPv6 access list configuration mode. To remove the access list, use the no form of this
command.
This command is available only if the switch is running the advanced IP services image and you have
Note
configured a dual IPv4 and IPv6 Switch Database Management (SDM) template on the switch.
Syntax Description
access-list-name
Defaults
No IPv6 access list is defined.
Command Modes
Global configuration
Command History
Release
12.2(25)SED
Usage Guidelines
To configure the dual IPv4 and IPv6 template, enter the sdm prefer dual-ipv4-and-ipv6 {default | vlan)
global configuration command and reload the switch.
The ipv6 access-list command is similar to the ip access-list command, except that it is IPv6-specific.
Note
IPv6 ACLs are defined by a unique name (IPv6 does not support numbered ACLs). An IPv4 ACL and
an IPv6 ACL cannot share the same name.
See the
on filtering IPv6 traffic based on IPv6 option headers and optional, upper-layer protocol-type
information. See the "Examples" section for an example of a translated IPv6 ACL configuration.
Catalyst 3560 Switch Command Reference
2-180
ipv6 access-list access-list-name
no ipv6 access-list access-list-name
Name of the IPv6 access list. Names cannot contain a space or quotation
mark or begin with a numeric.
Modification
This command was introduced.
ipv6 access-list
and
permit (IPv6 access-list configuration)
Chapter 2
Catalyst 3560 Switch Cisco IOS Commands
commands for more information
78-16405-05
Hide quick links:
Advertisement
Table of Contents
