Table of Contents
Advertisement
errdisable detect cause
errdisable detect cause
Use the errdisable detect cause global configuration command to enable error-disabled detection for a
specific cause or all causes. Use the no form of this command to disable the error-disabled detection
feature.
Syntax Description
all
arp-inspection
dhcp-rate-limit
dtp-flap
gbic-invalid
l2ptguard
link-flap
loopback
pagp-flap
Command Default
Detection is enabled for all causes.
Command Modes
Global configuration
Command History
Release
12.1(19)EA1
12.2(20)SE
12.2(25)SE
Catalyst 3560 Switch Command Reference
2-108
errdisable detect cause {all | arp-inspection | dhcp-rate-limit | dtp-flap | gbic-invalid |
l2ptguard | link-flap | loopback | pagp-flap}
no errdisable detect cause {all | arp-inspection | dhcp-rate-limit | dtp-flap | gbic-invalid |
l2ptguard | link-flap | pagp-flap}
Enable error detection for all error-disabled causes.
Enable error detection for dynamic Address Resolution Protocol (ARP)
inspection.
Enable error detection for DHCP snooping.
Enable error detection for the Dynamic Trunking Protocol (DTP) flapping.
Enable error detection for an invalid Gigabit Interface Converter (GBIC) module.
On the Catalyst 3560 switch, this error refers to an invalid small
Note
form-factor pluggable (SFP) module.
Enable error detection for a Layer 2 protocol-tunnel error-disabled cause.
Enable error detection for link-state flapping.
Enable error detection for detected loopbacks.
Enable error detection for the Port Aggregation Protocol (PAgP) flap
error-disabled cause.
Modification
This command was introduced.
The arp-inspection keyword was added.
The l2ptguard keyword was added.
Chapter 2
Catalyst 3560 Switch Cisco IOS Commands
78-16405-05
Hide quick links:
Advertisement
Table of Contents
