Table of Contents
Advertisement
6
152
Feature Dial
Services Codes
Cisco SRP500 Series Services Ready Platforms Administration Guide (SRP520 Models)
These codes tell the SRP what to do when the user is
listening to the first or second dial tone.
One or more *code can be configured into this
parameter, such as *72, or *72|*74|*67|*82, etc. Max total
length is 79 chars. This parameter applies when the
user has a dial tone (first or second dial tone). Enter
*code (and the following target number according to
current dial plan) entered at the dial tone triggers the
SRP to call the target number prepended by the *code.
For example, after user dials *72, the SRP plays a
special tone called a Prompt tone while awaiting the
user to enter a valid target number. When a complete
number is entered, the SRP sends a INVITE to *72
target_number as in a normal call. This feature allows
the proxy to process features like call forward (*72) or
Block Caller ID (*67).
The *codes should not conflict with any of the other
vertical service codes internally processed by the SRP.
You can empty the corresponding *code that you do not
want to the SRP to process.
You can add a parameter to each *code in Features Dial
Services Codes to indicate what tone to play after the
*code is entered, such as *72'c'|*67'p'. Below are a list of
allowed tone parameters (note the use of open quotes
surrounding the parameter w/o spaces)
'c' = <Cfwd Dial Tone>
'd' = <Dial Tone>
'm' = <MWI Dial Tone>
'o' = <Outside Dial Tone>
'p' = <Prompt Dial Tone>
's' = <Second Dial Tone>
'x' = No tones are place, x is any digit not used above
If no tone parameter is specified, the SRP plays Prompt
tone by default. If the *code is not to be followed by a
phone number, such as *73 to cancel call forwarding, do
not include it in this parameter. In that case, simply add
that *code in the dial plan and the SRP send INVITE
*73@..... as usual when user dials *73.
Configuring Voice
Configuring Voice Settings
Hide quick links:
Advertisement
Table of Contents
