Table of Contents
Advertisement
Preparing for Installation
Class 1 laser product. Statement 1008
Warning
Only trained and qualified personnel should be allowed to install, replace, or service this equipment.
Warning
Statement 1030
Warning
Read the installation instructions before connecting the system to the power source. Statement 1004
Warning
Before working on equipment that is connected to power lines, remove jewelry (including rings,
necklaces, and watches). Metal objects will heat up when connected to power and ground and can
cause serious burns or weld the metal object to the terminals. Statement 43
Warning
Do not stack the chassis on any other equipment. If the chassis falls, it can cause severe bodily injury
and equipment damage. Statement 48
This equipment is intended to be grounded. Ensure that the host is connected to earth ground during
Warning
normal use. Statement 39
When installing or replacing the unit, the ground connection must always be made first and
Warning
disconnected last. Statement 1046
To prevent the switch from overheating, do not operate it in an area that exceeds the maximum
Warning
recommended ambient temperature of 104°F (40°C). To prevent airflow restriction, allow at least
3 inches (7.6 cm) of clearance around the ventilation openings. Statement 17
Warning
Do not work on the system or connect or disconnect cables during periods of lightning activity.
Statement 1001
Warning
Ultimate disposal of this product should be handled according to all national laws and regulations.
Statement 1040
Cisco ME 6500 Series Ethernet Switch Installation Guide
3-2
Chapter 3
Installing the Switch
OL-8900-03
Hide quick links:
Advertisement
Table of Contents
