Table of Contents
Advertisement
Chapter 1
Basic Router Configuration
Command
Step 2
network ip-address
Example:
Router(config)# network 192.145.1.0
Router(config)# network 10.10.12.115
Router(config)#
Step 3
end
Example:
Router(config-router)# end
Router#
For complete information on the IP EIGRP commands, see the Cisco IOS Release 12.3 documentation
set. For more general information on EIGRP concepts, see
Configuration Example
The following configuration example shows the EIGRP routing protocol enabled in IP networks
192.145.1.0 and 10.10.12.115. The EIGRP autonomous system number is 109.
Execute the show running-config command from privileged EXEC mode to see this configuration.
!
router eigrp 109
!
Verifying Your Configuration
To verify that you have properly configured IP EIGRP, enter the show ip route command, and look for
EIGRP routes indicated by "D." You should see verification output similar to the following example.
Router# show ip route
Codes: C - connected, S - static, R - RIP, M - mobile, B - BGP
Gateway of last resort is not set
C
D
OL-5332-01
network 192.145.1.0
network 10.10.12.115
D - EIGRP, EX - EIGRP external, O - OSPF, IA - OSPF inter area
N1 - OSPF NSSA external type 1, N2 - OSPF NSSA external type 2
E1 - OSPF external type 1, E2 - OSPF external type 2
i - IS-IS, su - IS-IS summary, L1 - IS-IS level-1, L2 - IS-IS level-2
ia - IS-IS inter area, * - candidate default, U - per-user static route
o - ODR, P - periodic downloaded static route
10.0.0.0/24 is subnetted, 1 subnets
10.108.1.0 is directly connected, Loopback0
3.0.0.0/8 [90/409600] via 2.2.2.1, 00:00:02, Ethernet0/0
Cisco 850 Series and Cisco 870 Series Access Routers Software Configuration Guide
Purpose
Specifies a list of networks on which EIGRP is to
be applied, using the IP address of the network of
directly connected networks.
Exits router configuration mode, and enters
privileged EXEC mode.
Appendix B, "Concepts."
Configuring Enhanced IGRP
1-15
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
