Table of Contents
Advertisement
Chapter 1
Basic Router Configuration
Configure the ATM WAN Interface
This procedure applies only to the Cisco 857, Cisco 876, Cisco 877 and Cisco 878 models.
Perform these steps to configure the ATM interface, beginning in global configuration mode:
Command
Step 1
For the Cisco 878 model only:
controller dsl 0
mode atm
exit
Example:
Router(config)# controller dsl 0
Router(config-controller)# mode atm
Router(config-controller)# exit
Router(config)#
Step 2
interface type number
Example:
Router(config)# interface atm0
Router(config-int)#
Step 3
ip address ip-address mask
Example:
Router(config-int)# ip address 10.10.10.100
255.255.255.0
Router(config-int)#
Step 4
no shutdown
Example:
Router(config-int)# no shutdown
Router(config-int)#
Step 5
exit
Example:
Router(config-int)# exit
Router(config)#
Configure the Wireless Interface
The wireless interface enables connection to the router through a wireless LAN connection. For more
information about configuring a wireless connection, see
Connection,"
OL-5332-01
and the Cisco Access Router Wireless Configuration Guide.
Cisco 850 Series and Cisco 870 Series Access Routers Software Configuration Guide
Configuring Basic Parameters
Purpose
For routers using the G.SHDSL signaling, perform
these commands. Ignore this step for routers using
ADSL signaling.
Identifies and enters the configuration mode for an
ATM interface.
Sets the IP address and subnet mask for the ATM
interface.
Enables the ATM 0 interface.
Exits configuration mode for the ATM interface
and returns to global configuration mode.
Chapter 9, "Configuring a Wireless LAN
1-7
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
