Table of Contents
Advertisement
Chapter 9
Configuring a Wireless LAN Connection
Command
Step 5
bridge-group number
Example:
Router(config-subif)# bridge-group 1
Router(config-subif)#
Step 6
exit
Example:
Router(config-subif)# exit
Router(config)#
Repeat these steps to configure more subinterfaces, as needed.
Configuration Example
The following configuration example shows a portion of the configuration file for the wireless LAN
scenario described in the preceding sections.
!
bridge irb
!
interface Dot11Radio0
no ip address
!
broadcast-key vlan 1 change 45
!
!
encryption vlan 1 mode ciphers tkip
!
ssid cisco
!
ssid ciscowep
!
ssid ciscowpa
OL-5332-01
vlan 1
authentication open
wpa-psk ascii 0 cisco123
authentication key-management wpa
vlan 2
authentication open
vlan 3
authentication open
Cisco 850 Series and Cisco 870 Series Access Routers Software Configuration Guide
Purpose
Assigns a bridge group to the subinterface.
Note
When the bridge-group command is
enabled, the following commands are
automatically enabled, and cannot be
disabled. If you disable these commands
you may experience an interruption in
wireless device communication.
bridge-group 1
subscriber-loop-control
bridge-group 1 spanning-disabled
bridge-group 1
block-unknown-source
Exits subinterface configuration mode, and
enters global configuration mode.
Configuration Example
9-7
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
