Table of Contents
Advertisement
1
2
4
5
USING THE EXTRA SPOOL PIN AND THE NET
Extra spool pin
Use when embroidering with metallic thread.
1. Insert the extra spool pin into the end of the bobbin winder shaft.
2. Install the spool felt and the thread spool in that order, and then thread the upper
thread.
1 Insert the extra spool pin into the end of the bobbin winder shaft
2 Spool felt
3 Thread spool
*
When setting the thread spool, set it so that the thread winds off from the front of
the spool.
*
If using metallic thread, we recommend that you use a 90/14 home sewing machine needle.
Note
This method keeps the thread from twisting as it comes off the spool pin.
Net
If using special threads which wind quickly off the thread spool, attach a net to the spool before using.
*
Cut the net to match the size of the spool.
1 Net
2 Thread spool
3 Spool pin
4 Spool cap
4. Guide the thread as illustrated by the numbers and arrow
marks on the machine.
5. Lower the presser foot.
6. Thread the needle manually or using the auto-threading
device.
*
You do not need to pull the bobbin thread up before you
start sewing.
7. Pass the thread underneath the presser foot and pull it out
from the rear of the machine by about 5 cm.
Note
Always raise the presser foot before removing the upper thread
from the machine or damage may occur to the auto thread
tension unit.
1
4
3
4
2
3
2
1
19
- Quick Links:
- Principal Parts
Hide quick links:
Advertisement
Table of Contents
