Table of Contents
Advertisement
Supported Hardware Components
Warning
The power supplies are used in a 1 + 1 redundant configuration. There is no input switch on the faceplate of
the power supplies. A power supply is switched from Standby to On by way of a system chassis power switch.
The following table lists the power supplies that you can order:
Part Number
PWR-CHI-750WACR
PWR-CH1-950WDCR
Note
Power Supply LEDs
The following table describes the power supply LEDs:
Table 11: AC Power Supply LEDs
Power Supply Condition
No AC power to all power supplies
Power Supply Failure (includes over voltage, over
current, over temperature and fan failure)
Power Supply Warning events where the power
supply continues to operate (high temperature, high
power and slow fan)
AC Present/12 VSB on (PSU OFF)
Power Supply ON and OK
Power Supply Fans
The fans in the power supply module are used for cooling the power supply module itself while a system-level
cooling is provided by fans within the chassis. The power supplies do not depend on the system-level fans
for cooling. Fan-rotation sensors determine the fan failures
Never install an AC power module and a DC power module in the same chassis.
Statement 1050
Power Supply
Cisco Catalyst CW9800H1 Wireless Controller and Cisco Catalyst CW9800H2
Wireless Controller power supply module with 750W AC Power
Cisco Catalyst CW9800H1 Wireless Controller and Cisco Catalyst CW9800H2
Wireless Controllerpower supply module with 950W DC Power
Platform related information can be obtained through a programmable interface using openconfig-platform
model. However, power auditing per component is not supported.
Cisco Catalyst CW9800H1 and CW9800H2 Wireless Controllers Hardware Installation Guide
Green (OK) LED Status
OFF
OFF
OFF
1 Hz Blinking
ON
Power Supply LEDs
Amber (FAIL) LED Status
OFF
ON
1 Hz Blinking
OFF
OFF
25
Advertisement
Chapters
Table of Contents
