Table of Contents
Advertisement
Power Up and Initial Configuration
Note
You will be prompted for wireless configuration after the Day 0 banner.
For information on modifying the configuration after you create it, see the
Controller Software Configuration Guide
Reference
Note
Step 1
Navigate to the Day 0 setup wizard using the write erase command or directly on the Day 0 device.
Step 2
Configure the device management or service port in the deveice management interface set up. This interface enables
the basic configuration to access the device using the GUI. This is an optional configuration where you can opt to
configure only the wireless management interface and not the device management.
Configure device management interface?[yes]:
Step 3
Configure the device management IP to access the device using the GUI.
Configure static IP address? [yes]:
Enter the interface IP [GigabitEthernet0]: 192.168.1.10
Enter the subnet mask [GigabitEthernet0] [255.0.0.0]: 255.255.255.0
Step 4
Configure a static route to access the device using the GUI.
Interface belongs to VRF "Mgmt-intf". Please configure a static route on the VRF
Enter the destination prefix: 0.0.0.0
Enter the destination mask: 0.0.0.0
Enter the forwarding router IP: 10.104.170.1
Step 5
Enter the management username and password.
Enter the management username: cisco
Enter the password: ********
Reenter the password: ********
Step 6
Configure the wireless management if you haven't configured a device management interface.
Basic management setup is now complete. At this point, it is possible to save the above and
continue wireless setup using the webUI (for this, choose 'no' below)
Would you like to continue with the wireless setup? [yes]: yes
The setup command facility is entered automatically if there is no configuration on the controller when it is
booted into Cisco IOS-XE.
Guide.
Presently, there is no direct method to get back to your previous configuration. Press Ctrl-C to restart the
configuration and return to the setup without saving the configuration.
Cisco Catalyst CW9800H1 and CW9800H2 Wireless Controllers Hardware Installation Guide
Using the Cisco IOS-XE CLI - Cisco Setup Command Facility
and the
Cisco Catalyst 9800 Series Wireless Controller Command
Cisco Catalyst 9800 Series Wireless
61
Advertisement
Chapters
Table of Contents
