Table of Contents
Advertisement
Using the Cisco IOS-XE CLI - Cisco Setup Command Facility
If you have not configured the device management, the setup moves to Step 8 before displaying the above
Note
banner.
You will be allowed to exit the wizard after configuring at least one of the interfaces, that is, device or
wireless management.
If you select Yes, you need to follow the upcoming steps. Also, you can access the device using the IP
configured in Step 4.
Step 7
Configure the Wireless management interface:
Configuring wireless management interface
Select interface to be used for wireless management
1. TenGigabitEthernet0/0/1 [Up]
2.
[Up]
3. TenGigabitEthernet0/0/3 [Up]
Choose the interface to config [1]:
Step 8
Enter a VLAN ID:
Enter the vlan ID (1-4094): 112
Step 9
Configure an IPv4 or IPv6 address:
Configure IPv4 address? [yes]:
Enter the interface IP [TenGigabitEthernet0/0/1]: 9.11.112.40
Enter the subnet mask [TenGigabitEthernet0/0/1] [255.0.0.0]: 255.255.255.0
Configure IPv6 address? [yes]: no
Step 10
Configure a VLAN DHCP server and IP address:
Do you want to configure a VLAN DHCP Server? [yes]: yes
Enter the VLAN DHCP Server IP [TenGigabitEthernet0/0/1]: 9.11.112.45
Step 11
(Optional) Setting a static route to attach an AP client to the controller. The default options for static route prompts you
to configure a default route. However, you can specify a different route as well.
Configure static route? [yes/no]: yes
Enter the destination prefix [0.0.0.0]:
Enter the destination mask [0.0.0.0]:
Enter the forwarding router IP: 9.11.112.1
Note
If you configure the device as HA RMI and you haven't configured a default route (that is, source and
destination as 0.0.0.0), the wizard asks for the default route information.
Basic management setup is now complete. At this point, it is possible to save the above and
continue wireless setup using the webUI(for this, choose 'no' below)
Would you like to continue with the wireless setup? [yes]
Step 12
Choose the deployment mode:
Choose the deployment mode
1. Standalone
2. Active
3. Standby
Enter your selection [1]:
Cisco Catalyst CW9800H1 and CW9800H2 Wireless Controllers Hardware Installation Guide
62
Power Up and Initial Configuration
Advertisement
Chapters
Table of Contents
