Table of Contents
Advertisement
Connect Router to the Network
Removing the Transceiver Module
Caution
To remove a transceiver module, follow these steps:
Step 1
Disconnect the network interface cable from the transceiver connector.
Step 2
Install the dust plug immediately into the transceiver's optical bore.
Step 3
Grasp the pull-tab and gently pull to release the transceiver from the socket.
Figure 14: Removing the QSFP Transceiver Module
Connect Interface Ports
You can connect optical interface ports with other devices for network connectivity.
Connect a Fiber-Optic Port to the Network
100G, or 400G transceivers are supported on Cisco
optic cables that you attach to the transceivers and other transceivers work with pre-attached copper cables.
You must install a transceiver in the port before installing the fiber-optic cable in the transceiver.
Caution
The transceiver module is a static-sensitive device. Always use an ESD wrist strap or similar individual
grounding device when handling transceiver modules or coming into contact with modules.
Removing and installing a transceiver can shorten its useful life. Do not remove and insert transceivers any
more than is absolutely necessary. We recommend that you disconnect cables before installing or removing
transceivers to prevent damage to the cable or transceiver.
.Some transceivers work with fiber-
Hardware Installation Guide for Cisco CQ211L01 Switch
Removing the Transceiver Module
35
Advertisement
Chapters
Table of Contents
