Table of Contents
Advertisement
Removing the Transceiver Module
Removing the Transceiver Module
Caution
To remove a transceiver module, follow these steps:
Step 1
Disconnect the network interface cable from the transceiver connector.
Step 2
Install the dust plug immediately into the transceiver's optical bore.
Step 3
Grasp the pull-tab and gently pull to release the transceiver from the socket.
Figure 32: Removing the QSFP Transceiver Module
Step 4
Slide the transceiver out of the socket.
Step 5
Place the transceiver module into an antistatic bag.
Connect Interface Ports
You can connect optical interface ports with other devices for network connectivity.
Connect a Fiber-Optic Port to the Network
Some transceivers work with fiber-optic cables that you attach to the transceivers and other transceivers work
with pre-attached copper cables. You must install a transceiver in the port before installing the fiber-optic
cable in the transceiver.
Cisco Nexus 9804 NX-OS Mode Switch Hardware Installation Guide
44
The transceiver module is a static-sensitive device. Always use an ESD wrist strap or similar individual
grounding device when handling transceiver modules or coming into contact with modules.
Connect Switch to the Network
Advertisement
Table of Contents
