Vertically Mounting The Ap With Dc Supply To A Wall - Cisco C9124AXE-E Installation Manual

Table of Contents

Vertically Mounting the AP with DC Supply to a Wall

Materials Required

Outdoor rated shielded Ethernet cable

Ground lug (provided with the access point)

Ground block and rod

Crimping tool for ground lug, Panduit CT-720 with CD-720-1 die

#6 AWG ground wire

Procedure

Step 1

Select a mounting location on the pole to mount the AP. You can attach the AP to a pole having a diameter

of 2 to 5 inch (51 to 127 mm).

Step 2

Hold the bracket up against the pole and slide the two band straps through the top and bottom sets of mounting

slots on the mounting bracket.

Step 3

Wrap the band straps around the pole, lock them, and then lightly tighten the clamps using a wrench. Only

tighten them enough to keep the bracket from sliding down the pole

Step 4

Screw an M6 bolt into each of the four bolt holes on the backside of the AP. Do not screw the bolt in all the

way. Leave a gap of about 0.13 inch (3.3 mm).

Step 5

Position the four bolts on the AP into the bracket keyhole slots. Ensure that the AP is seated correctly in the

slots.

Note

Step 6

Using a 10–mm wrench, tighten the four bolts that connect the AP to the bracket to 40 lbf-in (4.5 Nm) of

torque.

Step 7

Locate the AP to its final position. Tighten the band clamps with the wrench so that the AP does not slide on

the pole. Ensure that the clamps are tight enough not to let the AP move.

Step 8

Proceed with installing antennas (only for external antenna models), connecting the data cables, grounding

the AP, powering, and configuring the AP.