Table of Contents
Advertisement
Sala
Manual de instrucciones
(# FA ER AAS
STEREO TUNER
AMPLIFIER
AMPLIFICADOR
CON SINTONIZADOR
ESTEREO
UBRBERUAR
SxX-J720/SX-J420/SX-J320
SOUND FIELD PROCESSOR
SOUND IMAGE CONTROLLER
PROCESADOR DE CAMPO SONORO
CONTROLADOR DE IMAGEN SONORA
BE
IB Se
BERS was
SP-J720K/SP-J420
GR-J320
STEREO DOUBLE CASSETTE TAPE DECK
GRABADORA DE DOBLE CASETE ESTEREOFONICA
TBS EAE
CT-J720WR/CT-J3S20WR
AUTO RETURN STEREO TURNTABLE
GIRADISCOS ESTEREOFONICO CON RETORNO AUTOMATICO
BHU
TRR Eee
PL-J210
SPEAKER SYSTEM*
SISTEMA DE ALTAVOCES*
RRR
S-J720V/S-J4a20V
*The speaker systems may differ depending on the systemconfiguration.
*E| sistema de altavoces puede diferir dependiendo de fa configuracidén del sistema.
* HGR
AARC,
Tha ROTHER APNE,
English
VOLTAGE SELECTOR SWITCHES
Mains voltages in Saudi Arabia are 127V and 220V only. Never
use this model with a 110V setting in Saudi Arabia.
The fine voltage selector switches are on the rear panel. Before
3. Next, insert a screwdriver in the groove of the voltage selector
at the left and adjust unti! the voltage is the same as at the
right.
<Round 2-pin AC plug model>
your model is shipped from the factory, these switches are set to
1. Use a medium-size screwdriver.
the power requirements of the destination. Check that they are
2. insert a screwdriver in the groove of the voltage selecter, and
set properly before plugging the power cord into the-household
adjust so that the tip of the groove points to the voltage value
area where the voltage requirements differ, adjust the selector
switches as follows.
<Flat blade 2-pin AC plug model>
1, Use a medium-size screwdriver,
2, First, insert a screwdriver in the groove of the voltage selector
at the right, and adjust so that the tip of the groove points to
the voltage value of your area.
[Tuner amplifier]
<Flat blade 2-pin
AC plug model>
<Round 2-pin
AC piug mode! v
INFORMATION TO USER
Alteration or modifications carried out without appropriate authorization may invalidate the users right to operate the equipment.
INFORMATION TO USER
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment
|
generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause
harmful
interference
to radio communications.
However, there is no guarantee that interference will not occur in a particular
installation. if this equipment does cause harmful interference to radio or television reception, which can be determined by turning
the equipment off and on, the user is encouraged to try to correct the interference by one or more of the follawing measures:
~ Reorient or relocate the receiving antenna.
~ increase the separation between the equipment and receiver.
~ Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
— Consuit the dealer or an experienced radio/TV technician for help.
.
|
|
|
Advertisement
Table of Contents
