Table of Contents
Advertisement
Fluidmesh 1200 VOLO
To use the constant ping and automatic reboot functions, do the following
steps:
1.
Click the -ping softdog link under NETWORK CONTROL in the
left-hand settings menu.
• The PING SOFTDOG dialog will be shown
2.
To set up a constant ping to one or more IP addresses, do the
following steps:
1. Enter the IP address in the field to the left of the Add IP
2. Click the Add IP button.
3. To delete an IP address from the IP list, click the red
3.
To automatically reboot the unit if connectivity is lost between the
unit and any IP address, do the following steps:
1. Check the Reboot: check-box.
2. Click the Save button.
© 2020 Cisco and/or its affiliates. All rights reserved.
TIP
As well as being a fail-safe mechanism to monitor network
connectivity, the constant ping can also be used as a 'keep-
alive' message to devices that need uninterrupted connectivity,
such as VoIP telephones.
(page
72)).
Figure 30. Configurator GUI (Ping Softdog dialog)
button.
• The IP Address will be added to the IP list.
• There is no limit on the number of IP addresses
that can be entered.
cross to the right of the IP address listing.
(Figure 30
Page 72 of 169
Advertisement
Table of Contents
