Table of Contents
Advertisement
Fluidmesh 1200 VOLO
To reset the radio to its factory default settings, do the steps that follow:
1.
Power ON the unit.
2.
Wait approximately 40 seconds for the unit to boot up.
3.
When the unit has completed its boot sequence, access the
RESET button as shown above, and press the button for 7
seconds.
• The LEDs will blink.
• The unit will be restored to factory default settings
• The unit will reboot.
• The administrator user name and password will both be
5.1.6. Suitability for outdoor installation
The Fluidmesh 1200 VOLO was specifically designed for installation in
harsh outdoor environments. Under operating conditions, the unit is
completely sealed, and is capable of high-performance operation in
outdoor environments, and under severe conditions such as water spray,
salt, and extreme fluctuations in cold and heat.
The Fluidmesh 1200 VOLO has an IP66 ingress protection rating.
© 2020 Cisco and/or its affiliates. All rights reserved.
(including its default IP address of 192.168.0.10 and
subnet mask of 255.255.255.0).
reset to admin.
Page 34 of 169
Advertisement
Table of Contents
