Table of Contents
Advertisement
Fluidmesh 1200 VOLO
Figure 47. Multicast dialog (Mesh End mode)
4.
Compile the needed multicast rule. Use the following syntax rules
to create the rule:
• A multicast rule consists of two parts: a multicast group
• Define the multicast group designator. For example, the
• The destination address consists of one or more Fluidmesh
• Destination-address wildcards can also be used. For
5.
Enter the multicast group designator in the Multicast Group field.
6.
Enter the destination address in the Destination Address field.
7.
Click the add button.
• The new multicast route will be shown in the Multicast
To enable or disable multicast forwarding on a Bridge unit, do the
following steps:
1.
Connect to the Bridge unit as shown in
1200 VOLO for device configuration" (page
2.
Click the -multicast link under ADVANCED SETTINGS in the
left-hand settings menu
• The Multicast dialog will be shown.
© 2020 Cisco and/or its affiliates. All rights reserved.
designator and a destination address.
designator 224.1.1.0/24 indicates all multicast groups in
the range 224.1.1.1 through 224.1.1.254.
unit ID numbers, in the form 5.a.b.c. These ID numbers
belong to the physical Fluidmesh device or devices to
which the multicast traffic must be forwarded.
example, the destination address
5.255.255.255 represents all Fluidmesh units in the
wireless network.
routes section.
(Figure 48 (page
"Accessing the Fluidmesh
46).
96)).
Page 95 of 169
Advertisement
Table of Contents
