Table of Contents
Advertisement
Fluidmesh 1200 VOLO
5. Remove the hexagon nut and rubber seal from
the cable gland.
6. Make sure that the cable gland is securely
screwed into the bottom housing.
9. Correctly align the bottom housing with the
main body of the unit. Press the bottom housing
into the main body.
10. Tighten the two screws that secure the
bottom housing to the main housing.
© 2020 Cisco and/or its affiliates. All rights reserved.
IMPORTANT
The use of pre-made Ethernet
cables is recommended. The
rubber seal is pre-cut, allowing
pre-made Ethernet cables to be
used.
7. Route the LAN cables through the hexagon
nut, the rubber seal, and the cable gland on the
bottom housing.
CAUTION
If you are running only one
Ethernet cable through the
rubber seal, block the second
cable hole with a one-inch
cable stub only.
8. Connect the RJ45 connectors to the correct
LAN ports as shown in
"Connecting LAN cables
to the unit" (page
37).
11. Slide the rubber seal toward the unit until it
seats inside the cable gland.
12. Tighten the hexagon nut.
Page 38 of 169
Advertisement
Table of Contents
