Related Manuals for Toro 88713
Summary of Contents for Toro 88713
- Page 1 Form No. 3447-163 Rev B Pole Hedge Trimmer Attachment Flex-Force Power System ™ 60V MAX Attachment Model No. 88713—Serial No. 321000001 and Up *3447-163* Register at www.Toro.com. Original Instructions (EN)
- Page 2 This manual uses 2 words to highlight information. additional information, contact an Authorized Service Important calls attention to special mechanical Dealer or Toro Customer Service and have the model information and Note emphasizes general information and serial numbers of your product ready.
-
Page 3: Important Safety Instructions
Safety The Model 51810T Power Head is compatible with a variety of Toro-approved attachments that, when combined, comply with specific standards; see the following table for more detail. WARNING Combination Power Attachment Standard Read all safety warnings, instructions, Head Model... - Page 4 IV. Power tool use and care Use of a cord suitable for outdoor use reduces the risk of electric shock. Do not force the power tool. Use the correct If operating a power tool in a damp location power tool for your application. The correct is unavoidable, use a residual current device power tool will do the job better and safer at the (RCD) protected supply.
- Page 5 Do not heat the battery pack above 68°C (154°F) or incinerate it. Replace the battery pack with a genuine Toro battery pack only; using another type of battery pack may cause a fire or explosion. Keep...
- Page 6 VII. Hedge trimmer safety warnings To reduce the risk of electrocution, never use the extended-reach hedge trimmer near any electrical power lines. Contact with or use near power lines may cause serious injury or electric shock resulting in death. Always use two hands when operating the extended-reach hedge trimmer.
-
Page 7: Safety And Instructional Decals
Safety and Instructional Decals Safety decals and instructions are easily visible to the operator and are located near any area of potential danger. Replace any decal that is damaged or missing. decal145-3141 145-3141 decal145-3136 145-3136 1. Warning—read the Operator’s Manual; wear hearing protection;... - Page 8 Setup Loose Parts Use the chart below to verify that all parts have been shipped. Description Qty. – No parts required Install the harness. Connecting the Attachment to the Power Head Install the square shaft of the attachment into the square shaft of the power head (A of Figure Align the locking button on the lower shaft with the slotted hole on the upper shaft and slide the 2 shafts together (B and C of...
-
Page 9: Installing The Harness
Installing the Harness Connect the metal hook on the shoulder harness to the strap collar on the pole saw handle (Figure g364485 Figure 4 1. Strap adjuster 3. Strap collar 2. Metal strap hook 4. Shoulder strap The strap length is adjustable; slide the strap adjuster up to decrease the length of the strap, or down to increase the length of the strap (Figure... -
Page 10: Product Overview
Specifications Product Overview Model 88713, attaches to 51810T Cutting Length 406 mm (16 inches) Rated Voltage 60V DC maximum, 54 VDC nominal usage No-load Speed 3000 spm at 60 VDC max Cutting width 23 mm (9/10 inch) Weight 4.8 kg (10.6 lbs) -
Page 11: Operation
Rotating the Hedge Trimmer Operation Head Starting the Attachment The hedge trimmer head can rotate 90° for different cutting situations. Ensure that the vents on the attachment, power head, and battery are clear of any dust and Remove the battery pack; refer to Removing the debris. -
Page 12: Operating Tips
Shutting Off the Hedge Operating Tips Trimmer • Use the power tool for cutting in either direction in a slow, sweeping action from side to side. To shut off the hedge trimmer, release the run trigger • When trimming new growth, use a wide sweeping (Figure 8). -
Page 13: Maintenance
Maintenance Storage Remove the battery pack before maintenance or Important: Store the tool, battery pack, and cleaning work. charger only in temperatures that are within the appropriate range; refer to Specifications (page Use only the manufacturer’s recommended 10). replacement parts and accessories. Important: If you are storing the battery pack Inspect and maintain the product regularly. -
Page 14: Troubleshooting
Troubleshooting Perform only the steps described in these instructions. All further inspection, maintenance, and repair work must be performed by an authorized service center or a similarly qualified specialist if you cannot solve the problem yourself. Problem Possible Cause Corrective Action The tool does not start. - Page 15 Notes:...
- Page 16 While the exposure from Toro products may be negligible or well within the “no significant risk” range, out of an abundance of caution, Toro has elected to provide the Prop 65 warnings. Moreover, if Toro does not provide these warnings, it could be sued by the State of California or by private parties seeking to enforce Prop 65 and subject to substantial penalties.