Related Manuals for Toro Recycler 21469
Summary of Contents for Toro Recycler 21469
- Page 1 Form No. 3465-409 Rev A Flex-Force Power System ™ MAX 22in Recycler ® Lawn Mower Model No. 21469—Serial No. 400000000 and Up *3465-409* Register at www.Toro.com. Original Instructions (EN)
-
Page 2: Safety Alert Symbol
This manual uses two other words to highlight additional information, contact an Authorized Service information. Important calls attention to special Dealer or Toro Customer Service and have the model mechanical information and Note emphasizes general and serial numbers of your product ready. -
Page 3: Important Safety Instructions
Charge the battery pack with only the battery charger specified by Toro. A charger suitable for Read All Instructions 1 type of battery pack may create a risk of fire when used with another battery pack. - Page 4 Avoid discharging material against a with a Toro [replacement] bag. wall or obstruction; material may ricochet toward For best performance, use only genuine Toro you. Stop the blade(s) when crossing surfaces replacement parts and accessories. Other other than grass.
-
Page 5: Safety And Instructional Decals
• When you are not using the machine, store it Replace the battery pack with a genuine indoors in a dry, secure place out of the reach Flex-Force 60V lithium-ion battery pack of children. only; using another type of battery pack may cause a fire or risk of injury. - Page 6 Model 88980 decal161-3752 161-3752 1. Read the Operator’s 4. Keep away from open fire Manual . or flames 2. Recycle the battery 5. Do not expose to rain 3. Do not dispose improperly 6. Electrical shock hazard decal125-5026 125-5026 1. Recycling mode 2.
- Page 7 Model 88602 decal137-9462 137-9462 decal137-9463 137-9463 1. The battery pack is charging. 2. The battery pack is fully charged. 3. The battery pack is over or under the appropriate temperature range. 4. Battery pack charging fault...
- Page 8 Setup Important: The battery pack is not fully charged when it is purchased. Before using the machine for the first time, refer to Charging the Battery Pack (page 17). Mounting the Battery Charger (Optional) No Parts Required Procedure If desired, mount the battery charger securely on a wall using the wall-mount key holes on the back of the charger.
-
Page 9: Unfolding The Handle
Unfolding the Handle No Parts Required Procedure WARNING Folding or unfolding the handle improperly can damage the cables, causing an unsafe operating condition. • Do not damage the cable(s) when folding or unfolding the handle. • Ensure that the cable(s) are routed to the outside of the handle. •... -
Page 10: Assembling The Grass Bag
Assembling the Grass Bag No Parts Required Procedure g334351 Figure 5... -
Page 11: Product Overview
11. Rear deflector your Authorized Service Dealer or authorized Toro 6. Battery compartment distributor or go to www.Toro.com for a list of all approved attachments and accessories. To ensure optimum performance and continued safety certification of the machine, use only genuine Toro replacement parts and accessories. -
Page 12: Before Operation
Operation Before Operation Installing the Battery Pack Important: Use the battery pack only in temperatures that are within the appropriate range; refer Specifications (page 11). Ensure that the vents on the battery are clear of any dust and debris. Press down on the battery-compartment lid to open it (A of Figure Line up the cavity in the battery pack with the tongue on the machine and slide the battery pack into the compartment until it locks into place (B of... -
Page 13: Adjusting The Cutting Height
Adjusting the Cutting Height DANGER Adjusting the height-of-cut could bring your hands into contact with a moving blade and result in serious injury. • Shut off the motor, remove the battery, and wait for all moving parts to stop before adjusting the cutting height. -
Page 14: During Operation
During Operation Starting the Machine Ensure that the battery pack is installed in the machine; refer to Installing the Battery Pack (page 12). Note: If the battery-compartment lid does not close completely, the battery is not fully installed. Insert the electric-start button into the electric-start switch (A of Figure 11). -
Page 15: Bagging The Clippings
Bagging the Clippings Use the grass bag when you want to collect grass and leaf clippings from the lawn. If the bag-on-demand lever is in the recycling position, move it to the bagging position; refer to Operating the Bag-on-Demand Lever (page 15). -
Page 16: Shutting Off The Machine
• For best performance, install a new Toro blade before the cutting season begins or when necessary. Cutting Grass •... -
Page 17: After Operation
After Operation • If there are more than 13 cm (5 inches) of leaves on the lawn, mow at a higher cutting height and then again at the desired cutting height. Charging the Battery Pack • Slow down your mowing speed if the machine does not cut the leaves finely enough. -
Page 18: Cleaning Under The Machine
Cleaning Under the Refer to the following table to interpret the LED indicator light on the battery charger. Machine Indicator Indicates light Service Interval: After each use No battery pack inserted For best results, clean the machine soon after you Green Battery pack is charging have completed mowing. -
Page 19: Storing The Machine In The Vertical-Stow Position
g459225 Figure 18 To unfold the handle, refer to 2 Unfolding the Handle (page Storing the Machine in the Engage the handle locks. Vertical-Stow Position Lift the front of the machine by the handle and move it into a storage space (Figure 20). -
Page 20: Maintenance
Maintenance Remove the electric-start button and battery pack from the machine before maintaining or cleaning the machine. Always shut off the machine, wait for all moving parts to stop, and allow the machine to cool before adjusting, servicing, cleaning, or storing it. Use only the manufacturer’s recommended replacement parts and accessories. -
Page 21: Adjusting The Self-Propel Drive
Adjusting the Self-Propel Preparing the Battery Pack for Recycling Drive Important: Whenever you install a new self-propel cable or if Upon removal, cover the terminals of the self-propel drive is out of adjustment, adjust the the battery pack with heavy-duty adhesive tape. self-propel drive. - Page 22 Storage Important: Store the machine, battery pack, and charger only in temperatures that are within the appropriate range; refer to Specifications (page 11). Important: If you are storing the battery pack for the off-season, charge it until 2 or 3 LED indicators turn green on the battery.
-
Page 23: Troubleshooting
Troubleshooting Perform only the steps described in these instructions. All further inspection, maintenance, and repair work must be performed by an authorized service center or a similarly qualified specialist if you cannot solve the problem yourself. Problem Possible Cause Corrective Action The machine does not start. - Page 24 Problem Possible Cause Corrective Action The LED indicator light on the battery 1. There is an error in the communication 1. Remove the battery pack from the charger is blinking red. between the battery pack and the battery charger, unplug the battery charger.
- Page 25 Notes:...
- Page 26 Notes:...
- Page 27 While the exposure from Toro products may be negligible or well within the “no significant risk” range, out of an abundance of caution, Toro has elected to provide the Prop 65 warnings. Moreover, if Toro does not provide these warnings, it could be sued by the State of California or by private parties seeking to enforce Prop 65 and subject to substantial penalties.