Table of Contents
Advertisement
22in Recycler
Model No. 21462—Serial No. 400000000 and Up
Model No. 21464—Serial No. 400000000 and Up
Introduction
This rotary-blade, walk-behind lawn mower is intended
to be used by residential homeowners. It is designed
primarily for cutting grass on well-maintained lawns on
residential properties. Using this product for purposes
other than its intended use could prove dangerous to
you and bystanders.
Read this information carefully to learn how to operate
and maintain your product properly and to avoid
injury and product damage. You are responsible for
operating the product properly and safely.
Visit www.Toro.com for more information, including
safety tips, training materials, accessory information,
help finding a dealer, or to register your product.
Whenever you need service, genuine Toro parts, or
additional information, contact an Authorized Service
Dealer or Toro Customer Service and have the model
and serial numbers of your product ready.
identifies the location of the model and serial numbers
on the product. Write the numbers in the space
provided.
Important:
With your mobile device, you can
scan the QR code on the serial number decal (if
equipped) to access warranty, parts, and other
product information
1. Model and serial number location
Model No.
Serial No.
This manual identifies potential hazards and has
safety messages identified by the safety-alert symbol
(Figure
2), which signals a hazard that may cause
© 2020—The Toro® Company
8111 Lyndale Avenue South
Bloomington, MN 55420
®
Figure 1
Figure 1
Register at www.Toro.com.
Lawn Mower
serious injury or death if you do not follow the
recommended precautions.
This manual uses 2 words to highlight information.
Important calls attention to special mechanical
information and Note emphasizes general information
worthy of special attention.
It is a violation of California Public Resource Code
Section 4442 or 4443 to use or operate the engine on
any forest-covered, brush-covered, or grass-covered
land unless the engine is equipped with a spark
arrester, as defined in Section 4442, maintained in
effective working order or the engine is constructed,
equipped, and maintained for the prevention of fire.
The enclosed engine owner's manual is supplied
for information regarding the US Environmental
Protection Agency (EPA) and the California Emission
Control Regulation of emission systems, maintenance,
and warranty. Replacements may be ordered through
the engine manufacturer.
Gross or Net Torque: The gross or net torque
of this engine was laboratory rated by the engine
manufacturer in accordance with the Society of
Automotive Engineers (SAE) J1940 or J2723. As
configured to meet safety, emission, and operating
g282707
requirements, the actual engine torque on this class
of mower will be significantly lower. Please refer to
the engine manufacturer's information included with
the machine.
Form No. 3441-821 Rev A
Operator's Manual
Figure 2
Safety-alert symbol
*3441-821*
Original Instructions (EN)
Printed in Mexico
All Rights Reserved
g000502
Advertisement
Table of Contents
Related Manuals for Toro Recycler 21464
Summary of Contents for Toro Recycler 21464
-
Page 1: Introduction
Authorized Service land unless the engine is equipped with a spark Dealer or Toro Customer Service and have the model arrester, as defined in Section 4442, maintained in and serial numbers of your product ready. -
Page 2: Table Of Contents
Contents WARNING CALIFORNIA Introduction ............... 1 Safety ............... 3 Proposition 65 Warning General Safety ........... 3 The engine exhaust from this product Safety and Instructional Decals ......4 contains chemicals known to the State of Setup ................ 6 California to cause cancer, birth defects, 1 Assembling and Unfolding the Handle.... -
Page 3: Safety
Safety This machine has been designed in accordance with ANSI B71.1-2017. General Safety This product is capable of amputating hands and feet and of throwing objects. Always follow all safety instructions to avoid serious personal injury or death. • Read, understand, and follow the instructions and warnings in this Operator’s Manual and on the machine and attachments before starting the engine. -
Page 4: Safety And Instructional Decals
Safety and Instructional Decals Safety decals and instructions are easily visible to the operator and are located near any area of potential danger. Replace any decal that is damaged or missing. decaloemmarkt Manufacturer's Mark 1. This mark indicates that the blade is identified as a part from the original machine manufacturer. - Page 5 Electric-start model only decal133-8062 133-8062 decal140-4357 140-4357 1. Warning—read the 2. Attention—read the Operator’s Manual for Operator’s Manual battery information; do not for battery charging discard the lead battery. information. Electric-start model only decal133-1900 133-1900 1. Read the Operator’s Manual for more information on starting 2.
-
Page 6: Setup
Setup Important: Remove and discard the protective plastic sheet that covers the engine and any other plastic or wrapping on the machine. Important: To prevent accidental starting, do not insert the electric-start button into the electric-start ignition (if equipped) until you are ready to start the engine. Assembling and Unfolding the Handle No Parts Required Procedure... -
Page 7: Installing The Recoil-Starter Rope In The Rope Guide
Installing the Recoil-Starter Rope in the Rope Guide No Parts Required Procedure Important: To start the engine safely and easily whenever you use the machine, install the recoil-starter rope in the rope guide. g334093 Figure 4... -
Page 8: Adding Oil To The Engine
Adding Oil to the Engine No Parts Required Procedure Important: If the oil level in the engine is too low or too high and you run the engine, you may damage the engine. g222533 Figure 5... -
Page 9: Assembling The Grass Bag
Assembling the Grass Bag No Parts Required Procedure g334351 Figure 6 Charging the Battery No Parts Required Procedure Electric-Start Model Only Refer to Charging the Battery (page 23). -
Page 10: Product Overview
Contact your Authorized Service Dealer or authorized Toro distributor or go to www.Toro.com for a list of all approved attachments and accessories. To ensure optimum performance and continued safety certification of the machine, use only genuine Toro replacement parts and accessories. -
Page 11: Filling The Fuel Tank
Fuel Safety Filling the Fuel Tank • Fuel is extremely flammable and highly explosive. Type Unleaded gasoline A fire or explosion from fuel can burn you and others and can damage property. Minimum octane rating 87 (US) or 91 (research octane;... -
Page 12: Checking The Engine-Oil Level
Checking the Engine-Oil Level Service Interval: Before each use or daily Important: If the oil level in the crankcase is too low or too high and you run the engine, you may damage the engine. g231765 Figure 10 Adjusting the Handle Height You can raise or lower the handle in 1 of 2 positions that is more comfortable for you (Figure 11). -
Page 13: Adjusting The Cutting Height
Adjusting the Cutting Height DANGER Adjusting the cutting-height levers could bring your hands into contact with a moving blade and result in serious injury. • Shut off the engine, remove the electric-start button (if equipped), and wait for all moving parts to stop before adjusting the cutting height. -
Page 14: During Operation
Check the grass catcher components and the discharge chute frequently for any wear or • Do not operate the machine while ill, tired, or deterioration and replace them with genuine Toro under the influence of alcohol or drugs. parts when necessary. •... -
Page 15: Starting The Engine
Starting the Engine You can start the engine using either the electric-start button (if equipped) or the recoil-start handle. Starting the Engine Using the Electric-Start Button For Electric-Start Models Hold the blade-control bar against the handle (A of Figure 13). If the electric-start button has been removed, insert it in the electric starter (B of Figure 13). -
Page 16: Using The Self-Propel Drive
Using the Self-Propel Drive Recycling the Clippings To operate the self-propel drive, simply walk with your Your machine comes from the factory ready to recycle hands on the upper handle and your elbows at your the grass and leaf clippings back into the lawn. sides, and the machine will automatically keep pace If the grass bag is on the machine and the with you... -
Page 17: Bagging The Clippings
Bagging the Clippings Use the grass bag when you want to collect grass and leaf clippings from the lawn. If the bag-on-demand lever is in the recycling position, move it to the bagging position; refer to Operating the Bag-on-Demand Lever (page 18). -
Page 18: Operating The Bag-On-Demand Lever
(if equipped), disconnect the wire from the spark plug, and examine the machine for damage. • For best performance, install a new Toro blade before the cutting season begins or when necessary. Cutting Grass •... -
Page 19: After Operation
• If there are more than 13 cm (5 inches) of leaves When no more clippings come out, stop the on the lawn, mow at a higher cutting height and water and move the machine to a dry area. then again at the desired cutting height. Start the engine and run it for a few minutes to •... -
Page 20: Folding The Handle
Folding the Handle WARNING Folding or unfolding the handle improperly can damage the cables, causing an unsafe operating condition. • Do not damage the cables when folding or unfolding the handle. • If a cable is damaged, contact an Authorized Service Dealer. Remove the electric-start button (if equipped) as shown in A of Figure Remove and save the 2 handle knobs and 2 carriage bolts from the handle brackets (B of... -
Page 21: Maintenance
After performing the maintenance procedure(s), • To ensure optimum performance of the machine, connect the spark-plug wire to the spark plug. use only genuine Toro replacement parts and accessories. Replacement parts and accessories Important: Before tipping the machine to made by other manufacturers could be dangerous, change the oil or replace the blade, allow the and such use could void the product warranty. -
Page 22: Servicing The Air Filter
Servicing the Air Filter *There is residual oil in the crankcase after you drain the oil. Do not pour the entire capacity of oil into the Service Interval: Every 25 hours crankcase. Fill the crankcase with oil as directed in the following steps. -
Page 23: Charging The Battery
Note: Carefully pour about 3/4 of the engine capacity Your battery charger may have a 2-color LED of oil into the oil-fill tube. display that indicates the following states of charging: • A red light indicates that the charger is charging Wait 3 minutes for the oil to settle in the engine. -
Page 24: Replacing The Blade
Replacing the Blade Service Interval: Yearly Important: You will need a torque wrench to install the blade properly. If you do not have a torque wrench or are uncomfortable performing this procedure, contact an Authorized Service Dealer. Examine the blade whenever you run out of fuel. If the blade is damaged or cracked, replace it immediately. -
Page 25: Adjusting The Self-Propel Drive
Preparing the Machine for Storage On the last refueling of the year, add fuel stabilizer (such as Toro Premium Fuel Treatment) to the fuel as directed on the label. Dispose of any unused fuel properly. Recycle it according to local codes or use it in your automobile. -
Page 26: Removing The Machine From Storage
Removing the Machine from Storage Electric-start models only: Charge the battery for 24 hours; refer to 5 Charging the Battery (page Check and tighten all fasteners. Remove the spark plug and spin the engine rapidly by pulling the recoil-start handle to blow the excess oil from the cylinder. - Page 27 California Proposition 65 Warning Information What is this warning? You may see a product for sale that has a warning label like the following: WARNING: Cancer and Reproductive Harm—www.p65Warnings.ca.gov. What is Prop 65? Prop 65 applies to any company operating in California, selling products in California, or manufacturing products that may be sold in or brought into California.