Engaging The Auger; Disengaging The Auger; Self-Propelling The Machine; Shutting Off The Engine - Toro SnowMaster 724 ZXR Operator's Manual
Snowthrower
Hide thumbs
Also See for SnowMaster 724 ZXR:
- Operator's manual (44 pages) ,
- Operator's manual (20 pages)
Table of Contents
Advertisement
Engaging the Auger
Figure 12
Disengaging the Auger
To disengage the auger, release the auger lever.
Self-Propelling the Machine
To operate the self-propel drive, simply walk with your
hands on the upper handle and your elbows at your
sides, and the machine will automatically keep pace
with you
(Figure
13).
Note:
You can self-propel the machine with the auger
engaged or disengaged.
Figure 13
Shutting Off the Engine
To shut off the engine, remove the key from the
ignition or move the key to the middle position.
Adjusting the Discharge
Chute and Chute Deflector
To raise or lower the angle of the chute deflector,
press the trigger on the chute deflector and move the
chute deflector up or down.
To adjust the discharge chute, move the chute handle.
Note:
Disengage the auger before adjusting the
chute or chute deflector.
g030453
1. Trigger
Clearing a Clogged
Discharge Chute
WARNING
If the auger/impeller is running but there is no
snow coming out of the discharge chute, the
discharge chute may be clogged.
Never use your hands to clear a clogged
discharge chute. This could result in personal
injury.
g030528
1.
While remaining in the operating position,
release the self-propel handle.
2.
Engage the auger.
3.
Push down on the handle to raise the front of
the machine a few centimeters (inches) off the
pavement, then lift the handles quickly to bump
the front of the machine onto the pavement.
9
Figure 14
2. Chute handle
g030530
Advertisement
Table of Contents
