hit counter script

Replacing The Spark Plug - Toro SnowMaster 724 ZXR Operator's Manual

Snowthrower
Hide thumbs Also See for SnowMaster 724 ZXR:
Table of Contents

Advertisement

9.
Wipe the dipstick clean with a clean cloth.
10.
Insert the dipstick into the oil-fill tube, do not
screw it in, then remove the dipstick.
11.
Read the oil level on the dipstick.
If the oil level on the dipstick is too low,
carefully pour a small amount of oil into the
oil-fill tube, wait 3 minutes, and repeat steps
9
through
11
until the oil level on the dipstick
is correct.
If the oil level on the dipstick is too high,
drain the excess oil until the oil level on the
dipstick is correct.
Important:
If the oil level in the engine is too
low or too high and you run the engine, you
may damage the engine.
12.
Install the dipstick into the oil-fill tube securely.

Replacing the Spark Plug

Service Interval: Every 100 hours—Replace the
spark plug.
WARNING
Replacing the spark plug while the engine is
hot can result in burns.
Wait until the engine is cool to replace the
spark plug.
Use a Toro spark plug or equivalent (Champion®
RN9YC or NGK BPR6ES).
1.
Remove the boot
1. Spark-plug boot
2.
Clean around the base of the spark plug.
3.
Remove and discard the old spark plug.
Note:
You will need a ratchet wrench extension
to remove the spark plug.
4.
Set the gap between the electrodes on a new
spark plug at 0.76 mm (0.030 inch) as shown
in
Figure
20.
1. 0.76 mm (0.030 inch)
14
(Figure
19).
Figure 19
Figure 20
g030123
g001029

Advertisement

Table of Contents
loading

This manual is also suitable for:

36001

Table of Contents