Table of Contents
Advertisement
Press the [START] key.
3
Scanning begins.
If you have another page to scan, change pages and then press the [START] key.
Repeat until all originals have been scanned.
4
If no action is taken for one minute, scanning automatically ends and the transmission is reserved.
Place next original.
Press [Start].
When finished, press [Read-End].
• When scanning is completed, "Job stored." will be displayed together with a job control number.
5
This number can be used to locate the job in the Transaction Report or in the Image Sending Activity Report.
• If no action is taken for one minute after the confirmation screen appears, scanning automatically ends and the
transmission is reserved.
• The [Configure] key can be touched to change the exposure, resolution, scan size, and send size for each original
page scanned. However, when "Card Shot" is selected in the special modes, only the exposure can be changed,
and this can only be done when scanning each even page number of the original pages.
To cancel transmission...
Press the [STOP] key (
• If a fax is being received when the transmission operation is performed, the transmission will be reserved and transmission
will take place after fax reception is completed.
• If the memory becomes full while the originals are being scanned, a message will appear and transmission will be
canceled.
(Pg.No.x)
Configure
Read-End
) before the [Read-End] key is touched.
4-35
Touch the [Read-End] key.
A beep sounds.
Open the automatic document feeder and remove the original.
FACSIMILE
Contents
Advertisement
Chapters
Table of Contents
Troubleshooting
