Related Manuals for Beko WMD 66160 S
Summary of Contents for Beko WMD 66160 S
- Page 1 WMD 66160 S Washing Machine WMD 66160 Lave-linge WMD 66140 S Wasmachine WMD 66140 Waschmaschine WMD 66120 S WMD 66120...
-
Page 2: Warnings General Safety
1 Warnings directives. Intended use General Safety • This product has been designed for • Never place your machine on a carpet home use. covered floor. Otherwise, lack of airflow • The appliance may only be used for from below of your machine may cause washing and rinsing of textiles that are electrical parts to overheat. This may marked accordingly. cause problems with your washing Safety instructions machine. • This appliance must be connected to • If the power cable or mains plug is an earthed outlet protected by a fuse of damaged you must call Authorized suitable capacity. Service for repair. • The supply and draining hoses must • Fit the drain hose into the discharge always be securely fastened and remain housing securely to prevent any water in an undamaged state. leakage and to allow machine to take • Fit the draining hose to a washbasin in and discharge water as required. It is or bathtub securely before starting up very important that the water intake and... -
Page 3: Installation Removing Packaging Reinforcement
2 Installation Removing packaging reinforcement Tilt the machine to remove the packaging reinforcement. Remove the packaging reinforcement by pulling the ribbon. Opening the transportation locks • If you are going to use your double Transportation safety bolts must be water-inlet machine as a single (cold) removed before operating the washing water-inlet unit, you must install the machine! Otherwise, the machine will be stopper*, supplied with your machine to damaged! the hot water valve. 1. Loosen all the bolts with a spanner until • If you want to use both water inlets of they rotate freely (“C”) the product, you can connect the hot 2. Remove transportation safety bolts by water hose after removing the stopper turning them gently. and gasket group from the hot water 3. Fit the covers (supplied in the bag with valve. the Operation Manual) into the holes on * Applies for the products supplied with a blind the rear panel. (“P”) stopper group. • Models with a single water inlet should not be connected to the hot water tap. -
Page 4: Electrical Connection
• The maximum length of the combined Loading door hoses must not be longer than 3.2 m. The door locks during program operation and the Door Locked Symbol lights up. The door Electrical connection can be opened when the symbol fades out. Connect the machine to an earthed outlet protected by a fuse of suitable capacity. Detergents and softeners Important: Detergent Drawer • Connection should comply with national The detergent drawer is composed of three regulations. compartments: • The voltage and the allowed fuse The detergent dispenser may be in two protection are specified in the section different types according to the model of your “Technical Specifications”. machine. • The specified voltage must be equal to – (I) for prewash your mains voltage. – (II) for main wash • Connection via extension cords or multi- - (III) siphon plugs should not be made. – ( ) for softener A damaged power cable must be replaced by a qualified electrician. -
Page 5: Turning The Machine On
4 Selecting a Program and Operating Your Machine Control panel Synthetisch Katoen Deur openen Coton Synthétique 90° Wassen Spoelen Centrifugeren 60° 60° Ouverture de Porte Lavage Rinçage Essorage 40° 40° 30° 30° Start/Pause Départ/Pause Sport 40 Super 40 Hemden Chemise Mini 30 Delicaat 60°... -
Page 6: Additional Programs
Additional programs program, and then select no spin function with spin speed selection button. Press “Start/ For special cases, there are also extra Pause/Cancel” button. programs available: You should use a lower spin speed for • Delicates delicate laundries. You can wash your delicate clothes on this program. It has more sensitive washing Spin Speed selection movements and does not make intermediate Whenever a new program is selected, the spinning compared to “Synthetic” program. maximum spin speed of the selected program • Shirt is displayed on the spin speed indicator. You can use this program to wash cottons To decrease the spin speed, press the “Spin” and synthetics together. There is no need to button. Spin speed decreases gradually. Then, sort them. rinse hold and no spin options are shown • Sport respectively. This program is suitable for clothes that Rinse hold is shown with “ ” and no spin is are normally worn for a short time such as shown with “ ” symbols. sportswear. It is used to quickly wash a small If you do not want to unload your clothes amount of cotton/synthetic blended clothes. -
Page 7: Program And Consumption Table
Program and consumption table Programme Duration (~min) Programme Cottons 2.18 • • • • • • Cottons 60** 1.14 • • • • • • Cottons 0.66 • • • • • • Super 0.87 • Babycare 1.29 * • • • Sports 0.56 •... -
Page 8: Auxiliary Functions
Auxiliary functions is running. Program duration may differ from the values in the consumption table Auxiliary Function Selection Buttons subject to the changes in the water pressure, Select the required auxiliary functions before water hardness and temperature, ambient starting the program. temperature, type and amount of laundry, Some combinations cannot be selected auxiliary functions selected, and changes in together. (Ex.: Pre-wash and Quick the supply voltage. Wash. Warning signal on the selected auxiliary Time delay function will light up. With the “Time delay” function you can delay the program start up to 24 hours. Time delay Auxiliary function selection can be set with steps of one hour for the first If an auxiliary function that should not be three hours and with steps of three hours for selected together with a previously selected the remainder (1, 2, 3, 6, 9, …24). function is chosen, the first selected function will be cancelled and the last auxiliary function 1. Pres “Time Delay” button to adjust the selection will remain active. desired time. (Ex.: If you want to select pre-wash first and 2. Press “Start/Pause/Cancel” button. The then quick wash, pre-wash will be cancelled time delay will start to count down. -
Page 9: Changing The Selections After The Program Has Started
unbalanced distribution of laundry in the 5 Maintenance and cleaning machine. Detergent Drawer Remove any powder residue buildup in the Changing the selections after the drawer. To do this; program has started 1. Press the dotted point on the siphon Turning the program knob while the program in the softener compartment and pull is in a normal flow will not change the towards you until the compartment is program. removed from the machine. Switching the machine to standby mode Press “Start/Pause/Cancel” button momentarily to switch your machine to the standby mode. Auxiliary functions can be cancelled or selected in accordance with the step the program is at. The door can be opened if the water level is suitable. Laundry may be added / taken out by opening the If more than a normal amount of water door. -
Page 10: Draining Any Remaining Water And Cleaning The Pump Filter
Draining any remaining water and end of the hose. If the amount of water cleaning the pump filter to be drained off is greater than the volume of the container, replace the Your product is equipped with a filter system plug, pour the water out, then resume which ensures a cleaner water discharge that the draining process. extends pump life by preventing solid items • After draining process is completed, such as buttons, coins and fabric fibers from replace the plug into the end of the clogging the pump propeller during discharge hose and fit the hose back into its of the washing water. place. • If your machine fails to drain the water, If your product is not supplied with an the pump filter may be clogged. You emergency drain hose, do the following as may have to clean it every 2 years or shown in the figure below: whenever it is plugged. Water must be drained off to clean the pump filter. In addition, water may have to be drained off completely in the following cases: • before transporting the machine (e.g. when moving house) • when there is the danger of frost In order to clean the dirty filter and discharge the water;... -
Page 11: Solution Suggestions For Problems
6 Solution suggestions for problems Problem Cause Explanation / Suggestion Machine may have switched to self Program cannot Reset your machine by pressing “Start/Pause/ protection mode due to be started or Cancel” button for 3 seconds. (see, Canceling an infrastructure problem selected. a Program) (such as line voltage, water pressure, etc.). Be sure the seals of the water inlet hoses are There is water There might be problems securely fitted. coming from with hoses or the pump Tightly attach the drain hose to the tap. the bottom of filter. Make sure that the pump filter is completely the machine. closed. Machine stopped Machine can stop It will resume operating when the voltage is shortly after temporarily due to low back to the normal level. -
Page 12: Specifications
7 Specifications Models Maximum dry laundry capacity (kg) Height (cm) Width (cm) Depth (cm) Net Weight (kg) 230 V / 50hz Electricity (V/Hz.) Total Current (A) 2200 2200 2200 2200 2200 2200 Total Power (W) 1600 1600 1400 1400 1200 1200 Spinning cycle (rpm max.) Specifications of this appliance may change without notice to improve the quality of the product. Figures in this manual are schematic and may not match your product exactly. Values stated on the machine labels or in the documentation accompanying it are obtained in laboratory in accordance with the relevant standards. Depending on operational and environmental conditions of the appliance, values may vary. This appliance’s packaging material is recyclable. Help recycle it and protect the environment by dropping it off in the municipal receptacles provided for this purpose. Your appliance also contains a great amount of recyclable material. It is marked with this label to indicate the used appliances that should not be mixed with other waste. This way, the appliance recycling organised by your manufacturer will be done under the best possible conditions, in compliance with European Directive 2002/96/EC on Waste Electrical and Electronic Equipment. Contact your town hall or your retailer for the used appliance collection points closest to your home. We thank you doing your part to protect the environment. 12 - EN...