Table of Contents
Advertisement
Cisco Webex Room Panorama and Room 70 Panorama
Introduction
Audio Output Line [n] Delay DelayMs
n: 1..6
To obtain lip-synchronization, you can configure each audio line output with an extra delay
that compensates for delay in other connected devices, for example TVs and external
loudspeakers. The delay that you set here is either fixed or relative to the delay on the HDMI
output, as defined in the Audio Output Line [n] Delay Mode setting.
Requires user role: ADMIN, INTEGRATOR
Default value: 0
Value space: Integer (0..290)
The delay in milliseconds.
Audio Output Line [n] Delay Mode
n: 1..6
You may add extra delay to an audio line output with the Audio Output Line [n] Delay
DelayMs setting. The extra delay added is either a fixed number of milliseconds, or
a number of milliseconds relative to the detected delay on the HDMI output (typically
introduced by the connected TV).
Requires user role: ADMIN, INTEGRATOR
Default value: Fixed
Value space: Fixed/RelativeToHDMI
Fixed: Any extra delay (DelayMs) added to the output, will be a fixed number of
millisecond.
RelativeToHDMI: Any extra delay (DelayMs) added to the output, will be relative to the
detected delay on the HDMI output. The actual delay is HDMI-delay + DelayMs. The
Audio Output Connectors Line [n] DelayMs status reports the actual delay.
D15439.02 Room Panorama and Room 70 Panorama Administrator Guide CE9.14, OCTOBER 2020.
Configuration
Peripherals
Maintenance
Audio Output Line [n] Equalizer ID
n: 1..6
Select the equalizer ID for the audio source that is connected to the output line.
Requires user role: ADMIN, INTEGRATOR
Default value: 1
Value space: Integer (1..8)
Set the equalizer ID.
Audio Output Line [n] Equalizer Mode
n: 1..6
Define the equalizer mode for the audio source that is connected to the line output.
Requires user role: ADMIN, INTEGRATOR
Default value: Off
Value space: Off/On
Off: No equalizer.
On: Enable the equalizer for the audio line output.
Audio Output Line [n] Level
n: 1..6
Set the gain on the Line output connector. The gain should be adjusted to fit the audio input
level of the connected device. The gain can be tuned in steps of 1 dB.
The maximum output level with 0 dB gain is 18 dBu.
Example: If he connected audio device has max input level 10 dBu, then you should set the
gain to 10 dBu - 18 dBu = -8 dB.
Requires user role: ADMIN, INTEGRATOR
Default value: 0
Value space: Integer (-24..0)
Range: Select the gain in decibel (dB).
www.cisco.com — Copyright © 2020 Cisco Systems, Inc. All rights reserved.
94
Administrator Guide
Device settings
Device settings
Appendices
Advertisement
Chapters
Table of Contents
