Table of Contents
Advertisement
Cisco Webex Room Panorama and Room 70 Panorama
Introduction
Connect the Touch 10 controller
Room Panorama
A Room Panorama installation has an Ethernet switch that
is mounted under the table, or close to the table.
Connect the Touch 10 to this switch as shown to
the right. Room Panorama supports up to two Touch
controllers.
Touch 10 set-up
Touch 10 is powered over Ethernet (PoE). Once
connected, the set-up procedure begins. Follow the
instructions on screen.
If Touch 10 needs software upgrade, new software will
be downloaded from the video conferencing device and
installed on the unit automatically as part of the set-up
procedure. Touch 10 restarts after the upgrade.
Room 70 Panorama
For Room 70 Panorama, see the next two pages.
D15439.02 Room Panorama and Room 70 Panorama Administrator Guide CE9.14, OCTOBER 2020.
Configuration
Peripherals
Peripherals
(page 1 of 5)
Contact information
The video conferencing device's
name or address is displayed in
the status bar when Touch 10 is
successfully connected to the
device.
Maintenance
Cisco Catalyst 3560CX-12PC-S
SYST
STAT
SPEED
PoE
STACK
MODE
CONSOLE
The Ethernet connector
is at the rear of Touch 10.
www.cisco.com — Copyright © 2020 Cisco Systems, Inc. All rights reserved.
58
Administrator Guide
Device settings
Appendices
1
3
5
7
9
11
13
14
1
2
4
6
8
10
12
POWER over ETHERNET 240W
SFP+
PoE rated Ethernet cable
2
Advertisement
Chapters
Table of Contents
