Table of Contents
Advertisement
Cisco Webex Room Panorama and Room 70 Panorama
Introduction
Conference FarEndControl SignalCapability
Define the far end control (H.224) signal capability mode.
Requires user role: ADMIN
Default value: On
Value space: Off/On
Off: Disable the far end control signal capability.
On: Enable the far end control signal capability.
Conference FarEndMessage Mode
Toggle whether it is allowed to send data between two devices in a point-to-point call,
for use with control systems or macros. Works with SIP calls only. This setting will enable/
disable the use of the xCommand Call FarEndMessage Send command.
Requires user role: ADMIN
Default value: Off
Value space: Off/On
Off: It is not possible to send messages between two devices.
On: It is possible to send messages between two devices in a point-to-point call.
Conference MaxReceiveCallRate
Define the maximum receive bit rate to be used when placing or receiving calls.
Note that this is the maximum bit rate for each individual call; use the Conference
MaxTotalReceiveCallRate setting to set the aggregated maximum for all simultaneous active
calls.
Requires user role: ADMIN
Default value: 20000
Value space: Integer (64..20000 )
The maximum receive call rate (kbps).
D15439.02 Room Panorama and Room 70 Panorama Administrator Guide CE9.14, OCTOBER 2020.
Configuration
Peripherals
Maintenance
Conference MaxTransmitCallRate
Define the maximum transmit bit rate to be used when placing or receiving calls.
Note that this is the maximum bit rate for each individual call; use the Conference
MaxTotalTransmitCallRate setting to set the aggregated maximum for all simultaneous active
calls.
Requires user role: ADMIN
Default value: 20000
Value space: Integer (64..20000)
The maximum transmitt call rate (kbps).
Conference MaxTotalReceiveCallRate
This configuration applies when using a device's built-in MultiSite feature (optional) to host a
multipoint video conference.
Define the maximum overall receive bit rate allowed. The bit rate will be divided fairly among
all active calls at any time. This means that the individual calls will be up-speeded or down-
speeded as appropriate when someone leaves or enters a multipoint conference, or when a
call is put on hold (suspended) or resumed.
The maximum receive bit rate for each individual call is defined in the Conference
MaxReceiveCallRate setting.
Requires user role: ADMIN
Default value: 20000
Value space: Integer (64..20000)
The maximum receive call rate (kbps).
www.cisco.com — Copyright © 2020 Cisco Systems, Inc. All rights reserved.
105
Administrator Guide
Device settings
Device settings
Appendices
Advertisement
Chapters
Table of Contents
