Brake Maintenance; Adjusting The Parking Brake - Toro 74915 Operator's Manual
With 60in or 72in turbo force side discharge mower
Hide thumbs
Also See for 74915:
- Service manual (188 pages) ,
- Operator's manual (76 pages) ,
- Operator's manual (76 pages)
Table of Contents
Advertisement
Figure 73
1. Hydraulic unit shrouds
Brake Maintenance
Adjusting the Parking Brake
Service Interval: After the first 100 hours
Every 500 hours thereafter
Check to make sure brake is adjusted properly. This procedure
must be followed after the first 100 hours or when a brake
component has been removed or replaced.
1. Drive the machine onto a level surface.
2. Disengage the blade control switch (PTO), move the
motion control levers to the neutral locked position
and set the parking brake.
3. Stop the engine, wait for all moving parts to stop, and
remove the key.
4. Raise the back of the machine up and support the
machine with jack stands.
DANGER
Mechanical or hydraulic jacks may fail to
support machine and cause a serious injury.
• Use jack stand when supporting machine.
• Do not use hydraulic jacks.
5. Remove the rear tires from the machine.
6. Remove any debris from the brake area.
7. Rotate the drive wheel release handle to the released
position. Refer to the Using the Drive Wheel
Release Valves section in Operation.
8. Measure the overall length of the compression spring.
The correct length should be between 1-1/2 and
1-9/16 inches (3.8 and 4.0 cm). If the spring length is
within this range, no adjustment is needed. If it is not,
proceed to step 9.
9. Hold the threaded rod end with a tool and adjust
the lock nut until the spring length is between 1-1/2
and 1-9/16 inches (3.8 and 4.0 cm) (Figure 74). Do
Not allow the cable to turn when the nuts are being
loosened.
46
Advertisement
Table of Contents
