Table of Contents
Advertisement
Run Express Setup
The CIP VLAN can be the same as the management VLAN, or you can isolate CIP traffic on another VLAN that
is already configured on the switch. The default CIP VLAN is VLAN 1. Only one VLAN on a switch can have
CIP enabled. If the CIP VLAN is different from the management VLAN, you must specify an IP address for the
CIP VLAN. Make sure that the IP address that you assign to the switch is not being used by another device in your
network.
For more information about the CIP VLAN settings, click Help on the toolbar.
b) After you finish filling in the fields in the Basic Settings window, click Switch Wide Settings.
Step 12
In the Switch Wide Settings window, complete the following tasks:
a) Fill out the fields as follows:
• Data VLAN: You can enable or disable the data VLAN with the button here.
• Voice VLAN: You can enable/disable Voice VLAN here.
• STP Mode (Optional): Select an STP Mode from the drop-down
• Bridge Priority: You can update, enable, or disable Bridge Priority here.
• Domain Name (Optional): Enter a valid Domain Name.
b) After you finish filling in the fields in the Switch Wide Settings window, click Day 0 Config Summary.
The Summary window displays the configuration settings that you made.
Step 13
In the Summarywindow, confirm that the settings are accurate and complete one of the following actions:
If the settings...
Are correct
Are not correct
After you click Submit, the following events occur:
a. The switch is configured and exits Express Setup mode.
b. The browser displays a warning message and tries to connect with the earlier switch IP address.
c. Success dialogue appears. Click OK.
Typically, connectivity between the computer and the switch is lost because the configured switch IP address is in a
different subnet from the IP address on the computer.
Step 14
Turn off DC power at the source, disconnect all cables to the switch, and install the switch in your network.
Step 15
If you changed the static IP address on your computer, change it to the previously configured static IP address.
What to do next
You can display Web UI by following these steps:
Cisco Catalyst IE9300 Rugged Series Switch Hardware Installation Guide
52
Then...
Click Submit to complete the initial setup.
a. Click the back button and make the required changes.
b. Navigate back to the Summary window.
c. Click Submit to complete the initial setup.
Express Setup
- Quick Links:
- Switch Models
- Front Panel
- Power Supplies
Hide quick links:
Advertisement
Table of Contents
