S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
Connecting the Cisco MDS 9200 Series
The Cisco MDS 9200 Series provides the following types of ports:
•
•
•
•
•
Caution
When running power and data cables in overhead or subfloor cable trays, Cisco strongly recommends
that power cables and other potential noise sources must be located as far away as practical from network
cabling that terminates on Cisco equipment. In situations where long parallel cable runs cannot be
separated by at least 3.3 ft (1 m), Cisco recommends shielding any potential noise sources by housing
them in a grounded metallic conduit.
This chapter includes the following topics:
•
•
•
•
•
OL-19588-01
Console port (interface module)—An RS-232 port that you can use to create a local management
connection.
COM1 port (interface module)—An RS-232 port that you can use to connect to an external serial
communication device such as a modem.
MGMT 10/100 Ethernet port (interface module)—An Ethernet port that you can use to access and
manage the switch by IP address, such as through the CLI or Cisco Fabric Manager.
Fibre Channel ports (supervisor and switching modules)—Fibre Channel ports that you can use to
connect to the SAN, or for in-band management.
Other port types provided by the optional module, if installed, such as the iSCSI and/or FCIP over
Gigabit Ethernet ports on the 4-port or 8-port IPS modules.
Preparing for Network Connections, page 3-2
Connecting to the Console Port, page 3-2
Connecting to the COM1 Port, page 3-4
Connecting to the MGMT 10/100 Ethernet Port, page 3-5
Connecting to a Fibre Channel Port, page 3-6
C H A P T E R
Cisco MDS 9200 Series Hardware Installation Guide
3
3-1