Cisco MDS 9200 Series Installation Manual page 65
Cisco systems hub/switch installation guide
Hide thumbs
Also See for MDS 9200 Series:
- Configuration manual (280 pages) ,
- Installation manual (164 pages) ,
- Release note (44 pages)
Table of Contents
Advertisement
Chapter 2
Installing the Cisco MDS 9200 Series
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
Step 3
Position the chassis in the rack, inserting the rear of the chassis between the front mounting rails (see
Figure
the front rack-mount brackets to the mounting rails (three per side).
If you are installing the optional cable guides, place the cable guides in front of the front rack-mount
brackets, and then pass the screws through the cable guides, front rack-mount brackets, and mounting
rail. You can install one or both cable guides; if installing a single cable guide, it can be installed on
either side.
Figure 2-4
3
1 Mounting rail
2 Front rack-mount
Step 4
From the back of the rack, position the longer slider rails with the ears away from the chassis and slide
them into the C brackets previously installed on the sides of the chassis (see
Step 5
Level the chassis (it may sag slightly towards the back) and attach the slider rails to the mounting rails
with the 12-24 x 3/4-in. or 10-32 x 3/4-in. screws, three per side.
OL-19588-01
2-4). Use the 12-24 x 3/4-in. or 10-32 x 3/4-in. screws (depending on the type of rack) to attach
Installing the Cisco MDS 9200 Series in the Rack
1
M D
S
9 2
1
1 6
i
2
3
4
5
6
7
8
9
10
11
12
13
14
LI NK
GE
1
LI NK
GE
2
2
bracket
3 Screws, 12-24 or 10-32
Cisco MDS 9200 Series Hardware Installation Guide
Installing the Chassis in a Cabinet or Rack
Figure
2-5).
2-9
Advertisement
Table of Contents
