Removing Other Switching Or Services Modules - Cisco MDS 9200 Series Installation Manual
Cisco systems hub/switch installation guide
Hide thumbs
Also See for MDS 9200 Series:
- Configuration manual (280 pages) ,
- Installation manual (164 pages) ,
- Release note (44 pages)
Table of Contents
Advertisement
Removing and Installing Components
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
To remove a CSM module from the chassis, follow these steps:
Step 1
Power off the module from the CLI. For information about the correct command to use, see the Cisco
MDS 9000 Family NX-OS Interfaces Configuration Guide.
Step 2
Ensure that the backup process has completed by verifying that all LEDs on the module have turned off.
This requires up to 10 minutes.
Loosen the two captive screws on the module.
Step 3
Remove the module from the chassis as follows:
Step 4
a.
b.
Place the module on an antistatic mat or antistatic foam if not immediately reinstalling it in another slot.
Step 5
Install a filler panel to keep dust out of the chassis and maintain consistent airflow if the slot will remain
Step 6
empty.
Warning
Removing Other Switching or Services Modules
To remove a switching or services module from the chassis, follow these steps:
Disconnect any network interface cables attached to the module.
Step 1
Loosen the two captive screws on the module.
Step 2
Remove the module from the chassis as follows:
Step 3
a.
b.
Place the module on an antistatic mat or antistatic foam if not immediately reinstalling it in another slot.
Step 4
Install a filler panel to keep dust out of the chassis and maintain consistent airflow if the slot will remain
Step 5
empty.
Cisco MDS 9200 Series Hardware Installation Guide
2-32
Place your thumbs on the left and right ejector levers (shown in
simultaneously rotate the levers outward to unseat the module from the backplane connector.
Grasp the front edge of the module and slide the module part of the way out of the slot. Place your
other hand under the module to support the weight of the module. Do not touch the module circuitry.
Blank faceplates and cover panels serve three important functions: they prevent exposure
to hazardous voltages and currents inside the chassis; they contain electromagnetic
interference (EMI) that might disrupt other equipment; and they direct the flow of cooling
air through the chassis. Do not operate the system unless all cards, faceplates, front covers,
and rear covers are in place.
Place your thumbs on the left and right ejector levers (shown in
simultaneously rotate the levers outward to unseat the module from the backplane connector.
Grasp the front edge of the module and slide the module part of the way out of the slot. Place your
other hand under the module to support the weight of the module. Do not touch the module circuitry.
Chapter 2
Statement 1029
Installing the Cisco MDS 9200 Series
Figure 2-18 on page
2-30) and
Figure 2-18 on page
2-30) and
OL-19588-01
Advertisement
Table of Contents
