Installing The Cisco Mds 9200 Series Rear-Facing Into Cabinet - Cisco MDS 9200 Series Installation Manual
Cisco systems hub/switch installation guide
Hide thumbs
Also See for MDS 9200 Series:
- Configuration manual (280 pages) ,
- Installation manual (164 pages) ,
- Release note (44 pages)
Table of Contents
Advertisement
Installing the Switch in a Cabinet with Insufficient Front Clearance
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
Figure 2-12
Note
b.
Installing the Cisco MDS 9200 Series Rear-Facing into Cabinet
To install the switch rear-facing into a cabinet using the rack-mount kit provided with the switch, for
cabinets with insufficient front-facing clearance, follow these steps:
Position the chassis in the rack, inserting the back of the chassis between the rear mounting rails (see
Step 1
Figure
the front rack-mount brackets to the mounting rails (three per side).
If you are installing the optional cable guides, place the cable guides in front of the front rack-mount
brackets, and then pass the screws through the cable guides, front rack-mount brackets, and mounting
rail. You can install one or both cable guides; if installing a single cable guide, it can be installed on
either side.
Cisco MDS 9200 Series Hardware Installation Guide
2-16
C Brackets for the Cisco MDS 9200 Series (Close-Up View)
Ensure the C bracket is oriented so that it blocks the fewest airflow holes on the chassis; the holes
should be slightly closer to the bottom of the brackets and the text on the back of the bracket
should be right side up.
Repeat with the other C bracket on the other side of the switch.
2-13). Use the 12-24 x 3/4-in. or 10-32 x 3/4-in. screws (depending on the type of rack) to attach
Chapter 2
Installing the Cisco MDS 9200 Series
OL-19588-01
Advertisement
Table of Contents
