Cisco MDS 9200 Series Installation Manual page 78
Cisco systems hub/switch installation guide
Hide thumbs
Also See for MDS 9200 Series:
- Configuration manual (280 pages) ,
- Installation manual (164 pages) ,
- Release note (44 pages)
Table of Contents
Advertisement
System Grounding
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
Step 2
Grasp the spring or alligator clip on the ESD wrist strap and momentarily touch the clip to a bare metal
spot (unpainted surface) on the rack. Cisco recommends that you touch the clip to an unpainted rack rail
so that any built-up static charge is then safely dissipated to the entire rack.
Attach either the spring clip or the alligator clip to the ground lug screw as follows (See
Step 3
a.
Note
b.
Figure 2-16
5
1
2
5
Cisco MDS 9200 Series Hardware Installation Guide
2-22
If you are using the ESD wrist strap that is supplied with the FRUs, squeeze the spring clip jaws
open, position the spring clip to one side of the system ground lug screw head, and slide the spring
clip over the lug screw head so that the spring clip jaws close behind the lug screw head.
The spring clip jaws do not open wide enough to fit directly over the head of the lug screw or
the lug barrel.
If you are using an ESD wrist strap that is equipped with an alligator clip, attach the alligator clip
directly over the head of the system ground lug screw or to the system ground lug barrel.
Attaching the ESD Wrist Strap to the System Ground Lug Screw
M D
S
9 2
1
1 6
i
2
3
4
5
6
7
8
9
10
1
ESD ground strap
Clip and grounding lug
System ground connector
11
12
13
14
L IN
K
G E
1
L IN
K
G E
2
2
3
4
3
4
Chapter 2
Installing the Cisco MDS 9200 Series
Side view of grounding lug (clip slid behind
screw)
Clip installed (behind screw)
Figure
2-16.):
OL-19588-01
Advertisement
Table of Contents
