Installing The Shelf Bracket Kit Into A Four-Post Eia Rack - Cisco MDS 9200 Series Installation Manual
Cisco systems hub/switch installation guide
Hide thumbs
Also See for MDS 9200 Series:
- Configuration manual (280 pages) ,
- Installation manual (164 pages) ,
- Release note (44 pages)
Table of Contents
Advertisement
Appendix A
Cabinet and Rack Installation
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
Installing the Shelf Bracket Kit into a Four-Post EIA Rack
Figure A-2
Figure A-2
1
1 Rack-mounting rail (4x)
2 Shelf bracket (2x)
3 Slider rail (2)
To install the shelf brackets in an EIA rack, follow these steps:
Position a shelf bracket inside the rack-mounting rails as shown in
Step 1
the front of the shelf bracket with the holes in the front rack-mounting rail. Then, attach the shelf bracket
to the front rack-mounting rail using a minimum of four 12-24 or 10-24 screws.
Note
Repeat with the other shelf bracket.
Step 2
Step 3
Verify that the shelf brackets are at the same height (using the level or tape measure as desired).
OL-19588-01
shows the installation of the shelf bracket kit into a four-post EIA rack.
Installing the Shelf Bracket Kit into an EIA Rack
2
The bottom hole of the shelf bracket should align with the bottom hole of a rack unit on the
rack-mounting rail (the hole immediately above the 1/2-in. spacing).
Cisco MDS 9000 Family telco and EIA Shelf Bracket
3
4
5
4 Crossbar
5 10-32 screws (2x)
Cisco MDS 9200 Series Hardware Installation Guide
Figure
A-2. Align the screw holes at
A-7
Advertisement
Table of Contents
