Table of Contents
Advertisement
Cisco uBR10-SRP-OC12SML DPT WAN Line Card for the Cisco uBR10012 Router
About Troubleshooting the Cisco uBR10-SRP-OC12SML DPT
WAN Line Card
Check the following items if a problem appears on one of the OC12SML DPT WAN line cards.
Verify that the card is securely seated in the chassis
Step 1
•
•
Step 2
Verify that the PRE modules are operating properly.
•
•
•
If both PREs are operating correctly, check the Power LEDs on each uBR10-SRP- OC12SML DPT WAN
Step 3
line card. Are the Power LEDs on each line card on (green)?
•
•
Is the STATUS LED on the Cisco uBR10-SRP- OC12SML DPT WAN line card is on?
Step 4
•
78-13602-01
Remove the line card and reinsert it, making sure that it firmly connects to the backplane and that
both captive screws are tightly connected.
While the card is out of the chassis, check for bent pins on the backplane.
–
If there are bent pins, contact TAC for instructions.
The Status LED is on (green).
The Fail LED is off.
No Alarm LED's are on (yellow).
If no, remove the line card and reinsert it, making sure that it firmly connects to the backplane and
that both captive screws are tightly connected.
If yes, proceed to the next step.
If no, check that the version of Cisco IOS you have loaded on the router supports the
Cisco uBR10-SRP- OC12SML DPT WAN line card.
About Troubleshooting the Cisco uBR10-SRP-OC12SML DPT WAN Line Card
Cisco uBR10-SRP-OC12SML DPT WAN Line Card
21
Advertisement
Table of Contents
