hit counter script

Pc Card Slots; Serial Ports - Cisco RSP8 Installation And Configuration Manual

Cisco systems route switch installation and configuration guide
Table of Contents

Advertisement

Product Description
Table 2
LED Label
Normal
CPU halt
Master
Slave
Slot 0 PC Card
Slot 1 PC Card
1. The RSP8 controls these LEDs and turns them on in parallel to indicate that the system is operational.

PC Card Slots

The RSP8 has two PC Card slots available. Either slot can support a Flash memory card or a Flash Disk.
Type I and Type II PC Cards can be used in PC Card slot 0 and slot 1. Type III PC Cards can be used in
slot 1. Not all Flash memory cards or Flash Disks that are commercially available are supported.
Other Flash memory card or Flash Disk limitations might apply. For additional information, refer to the
Note
"Related Documentation" section on page

Serial Ports

Two asynchronous serial ports on the RSP8, labeled Console and Auxiliary, allow you to connect
external terminal devices to monitor and manage the system. The console port is an Electronics
Industries Association/Telecommunications Industry Association (EIA/TIA)-232 receptacle (female)
that provides a data circuit-terminating equipment (DCE) interface for connecting a console terminal.
EIA/TIA-232 was known as recommended standard RS-232 before its acceptance as a standard by the
Note
Electronic Industries Association (EIA) and Telecommunications Industry Association (TIA).
The auxiliary port is an EIA/TIA-232 plug (male) that provides a data terminal equipment (DTE)
interface; the auxiliary port supports flow control and is often used to connect a modem, a channel
service unit (CSU), or other optional equipment for Telnet management.
Route Switch Processor (RSP8) Installation and Configuration Guide
8
RSP8 LEDs
Color
State
1
Green
On
1
Green
Off
Yellow
On
Green
On
Green
On
Green
On
Green
On
Indication
RSP is on and receiving +5V.
RSP is operating normally.
Processor hardware failure has been detected.
RSP is an active (HSA/HA configuration required).
RSP is a standby RSP (HSA/HA configuration required).
Flash Disk or PC Card in this slot is being accessed.
Flash Disk or PC Card in this slot is being accessed.
2.
OL-4920-02

Advertisement

Table of Contents
loading

Table of Contents

Save PDF