Table of Contents
Advertisement
Place the removed DIMM on an antistatic mat, and store it in an antistatic container to protect it from
Step 7
ESD damage.
Repeat
Step 8
This completes the DIMM removal procedure. Proceed to the next section to install the new DIMMs.
Installing New DIMMs
This section discusses the procedure for installing DIMMs on your RSP.
Use this procedure to install new DIMMs.
Note
Do not mix memory sizes. If installing two DIMMs, both DIMMs must be the same size.
Step 1
Remove the new DIMM from its antistatic container.
Step 2
Hold the DIMM between your thumbs and forefingers. (See
Note
Insert the connector edge of the DIMM straight into the socket.
Step 3
Caution
When inserting the DIMM, use firm but not excessive pressure. If you damage a socket, you will have
to return the RSP to the factory for repair.
Gently push the DIMM into the socket until the socket release levers close over the ends of the DIMM.
Step 4
(See
Figure 16
Check to see if the DIMM is seated properly. If the DIMM appears misaligned, carefully remove it and
Step 5
reseat it in the socket. Push the DIMM firmly back into the socket until first one and then the other socket
release lever moves into place.
Repeat
Step 6
This completes the procedure for installing DRAM DIMMs. Proceed to the following section to check
the installation.
OL-4920-02
Step 4
through
Step 7
for the remaining DIMM, if required for your upgrade.
The DIMM should be facing component-side down.
Figure
16.) If necessary, rock the DIMM gently back and forth to seat it properly.
Inserting the DIMM
Step 1
through
Step 5
above if you are replacing more than one DIMM.
Figure
Route Switch Processor (RSP8) Installation and Configuration Guide
Maintenance Information
13.)
77
Advertisement
Table of Contents
