Table of Contents
Advertisement
Disabling SLCR
To disable the Cisco 7500 Single Line Card Reload feature, use the no service single-slot-reload-enable
global configuration command on the Cisco 7500 series router.
Command
Router(config)# no service single-slot-reload-enable Disables single line card reloading for all of the line cards in the
Verifying Cisco 7500 SLCR
Use the show running-config command to verify that single line card reloading has been successfully
enabled on the Cisco 7500 series router. If the service single-slot-reload-enable line appears in the
command output, Cisco 7500 SLCR is enabled. If this line does not appear in the command output, Cisco
7500 SLCR is disabled.
SLCR Configuration Example
In the following example, SLCR is enabled for all lines cards in the Cisco 7500 series router:
Router(config)# service single-slot-reload-enable
In the following example, SLCR is disabled for all line cards in the Cisco 7500 series router:
Router(config)# no service single-slot-reload-enable
SLCR Troubleshooting Tips
The debug oir command is used to debug the online insertion and removal (OIR) feature (which is also
known as hot-swapping or power-on servicing). The debug oir command is often useful in debugging
problems related to OIR, including single line card reloading.
RPR, RPR+, SSO, and FSU Troubleshooting Tips
Use the commands in the table below to troubleshoot the RPR, RPR+, SSO, and FSU features on
Cisco 7500 series routers:
Command
Router# show diag
Router# show redundancy
Router# show version
OL-4920-02
Purpose
Cisco 7500 series router.
Purpose
Displays hardware information for the router.
Displays the redundancy mode of the RSP. This command also
displays information about the number of switchovers, system
uptime, RSP uptime, and reasons for any switchovers.
Displays image information for each RSP.
Route Switch Processor (RSP8) Installation and Configuration Guide
Enabling High Availability Features
63
Advertisement
Table of Contents
