Table of Contents
Advertisement
Chapter 6
Cisco ASR 1002 Router Overview and Installation
•
•
In addition to the preceding guidelines, review the precautions for avoiding excessive temperature
conditions in the
Table 6-5
Table 6-5
Cisco ASR 1002 Dimensions
Depth
Height
Width
Weight
Guidelines for an Equipment Shelf or Tabletop Installation
The chassis should already be in the area where you will install it. If you have not determined where to
install your chassis, see
site considerations.
If you are not rack-mounting your Cisco ASR1000 series chassis, place it on a sturdy equipment shelf
or tabletop.
When installing the Cisco ASR 1002 Router on an equipment shelf or tabletop, ensure that the surface
is clean and that you have considered the following:
•
•
•
•
•
•
•
OL-13208-03
Install rack stabilizers (if available) before you mount the chassis.
Provide an adequate chassis ground (earth) connection for your router chassis.
"Site Environmental Requirements" section on page
provides the Cisco ASR 1002 Router dimensions and weight information.
Cisco ASR 1002 Router Dimensions and Weight
22.50 in. (57.15 cm)
(including card handles, cable-management brackets, power
supply handles).
3.47 in. (8.813 cm) - 2RU rack-mount per EIA RS-310
17.25 in. (43.815 cm) - 19 inch rack-mount
40 lb (18.143 k) - fully configured
Cisco ASR 1000 Series Routers Components, page 2-1
The Cisco ASR 1002 Router requires at least 3 inches (7.62 cm) of clearance at the inlet and exhaust
vents (the front and top/rear sides of the chassis).
The Cisco ASR 1002 Router should be installed off the floor. Dust that accumulates on the floor is
drawn into the interior of the router by the cooling fans. Excessive dust inside the router can cause
overtemperature conditions and component failures.
There must be approximately 19 inches (48.3 cm) of clearance at the front and rear of the chassis to
install and replace FRUs, or to access network cables and equipment.
The Cisco ASR 1002 Router needs adequate ventilation. Do not install it in an enclosed cabinet
where ventilation is inadequate.
Have the cable-management bracket available if you plan to install it on the front of the chassis.
An adequate chassis ground (earth) connection exists for your router chassis (see the
Chassis Ground Connection" section on page
Always follow proper lifting practices as outlined in the
when handling the chassis.
Cisco ASR 1000 Series Aggregation Services Routers Hardware Installation and Initial Configuration Guide
Guidelines for an Equipment Shelf or Tabletop Installation
3-8.
6-23).
"Electrical Safety" section on page
for information about
"Attaching a
3-18,
6-11
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
