Table of Contents
Advertisement
Chapter 2
Installing Cisco MNM
Note
Step 8
Choose the hostname, and then press Enter.
Note
Press Enter to verify that the setup information is correct.
Step 9
Enter y to accept the default DNS domain and press Enter.
Step 10
Note
Enter y and press Enter to run the FlexLM daemon, which is provided with Cisco EMF.
Step 11
Note
Press Enter if you have a valid license file available on your network. If you do not have a valid license
Step 12
file, enter n.
Note
To obtain a license, see the
Note
If you do not have a valid license file, you can still continue with the installation. The installation process
continues, but you cannot start the Cisco EMF Server until a valid license key is provided and the
<CEMF_ROOT>/bin/cemf license command is run to update the license information.
Step 13
Enter the full name, including the path, of the license file and press Enter.
The installation process begins and takes several minutes. When the installation is complete, a message
indicates that the Cisco EMF Server Package installation completed satisfactorily.
This completes the Cisco EMF installation procedure on the management server.
If you are using a distributed configuration (with the management server and the presentation server),
continue installing Cisco EMF on the presentation server by following the steps in the
EMF 3.2 on the Management Server" section on page
performing the procedure described in the
Installing Cisco EMF 3.2 on the Presentation Server
Cisco EMF must be installed on the management server first, and the Cisco EMF server must be started
before a presentation client is installed.
Step 1
Log in as the root user on the presentation server where the Cisco EMF client is to be installed.
OL-18332-04
You can specify a separate disk to gain better performance.
If there is more than one hostnames, choose the correct hostname. If the correct hostname is not
listed in the menu, press Enter. Then enter the desired hostname and press Enter.
To change the default DNS domain, enter n, press Enter, specify the DNS domain, and press
Enter again.
To use an existing FlexLM daemon running on your system, enter n and press Enter.
"Task 6: Obtain a Cisco EMF License" section on page
2-8. Otherwise, continue the installation by
"Installing Cisco EMF Service Packs" section on page
Cisco Media Gateway Controller Node Manager Installation Guide
Performing a New Installation of Cisco MNM
2-6.
"Installing Cisco
2-10.
2-9
Advertisement
Table of Contents
