Installing a Cisco uBR10-LCP2-MC28C Cable Interface Line Card
Installing a Cisco uBR10-LCP2-MC28C Cable Interface Line Card
Tools and Parts Required
To remove and replace an individual cable interface line card you need the following tools and parts:
•
•
•
•
For proper cooling and airflow, you must always install a blank cable interface line card cover in a blank
Note
line card slot. The product order number for the blank cable interface line card cover is
UBR10-MC-Cover=.
Unpacking and Preparing
Make sure that you are using the ESD-preventive wrist strap.
Tip
Step 1
Open the shipping carton by cutting the packing tape along the flaps on the top of the box.
Step 2
Remove the cable interface line card.
Step 3
Place the cable interface line card on an anti-static surface or place it in an anti-static bag.
Removing a Cable Interface Line Card from the Chassis
Use the following procedure to remove the Cisco uBR10-LCP2-MC28C cable interface line card from
the Cisco uBR10012 router chassis.
To prevent alarms from activating, you must administratively shut down a cable interface line card before
hot swapping it. Refer to "Shutting Down and Restarting the Interface" in the Cisco uBR10012 Software
Configuration Guide at the following URL:
http://www.cisco.com/en/US/docs/cable/cmts/ubr10012/configuration/guide/scg.html
See the release notes at the following URL:
http://www.cisco.com/en/US/products/hw/cable/ps2209/prod_release_notes_list.html
Otherwise, inform the network administrator that this portion of the network will be temporarily
interrupted. If the maintenance LED is on, you can remove the cable interface line card without affecting
system operations.
Cisco uBR10-LCP2-MC28C Cable Interface Line Card for the Cisco uBR10012 Router
12
Replacement cable interface line card (order number UBR10-LCP2-MC28C=.
ESD-preventive wrist strap.
Anti-static surface or anti-static bag.
Blank line card cover (order number UBR10-MC-Covers=) if you are not replacing the card with
another card.
OL-4653-01