Cisco Firepower 2100 Getting Started Manual page 90
Hide thumbs
Also See for Firepower 2100:
- Getting started manual (232 pages) ,
- Manual (44 pages) ,
- Getting started manual (104 pages)
Table of Contents
Advertisement
Configure Interfaces
For example, add a zone called inside_zone. Each interface must be assigned to a security zone and/or
interface group. An interface can belong to only one security zone, but can also belong to multiple interface
groups. You apply your security policy based on zones or groups. For example, you can assign the inside
interface to the inside zone; and the outside interface to the outside zone. Then you can configure your
access control policy to enable traffic to go from inside to outside, but not from outside to inside. Most
policies only support security zones; you can use zones or interface groups in NAT policies, prefilter
policies, and QoS policies.
e) Click the IPv4 and/or IPv6 tab.
• IPv4—Choose Use Static IP from the drop-down list, and enter an IP address and subnet mask in
• IPv6—Check the Autoconfiguration check box for stateless autoconfiguration.
f) Click OK.
Step 4
Click the Edit (
The General tab appears.
Cisco Firepower 2100 Getting Started Guide
88
slash notation.
For example, enter 192.168.1.1/24
) for the interface that you want to use for outside.
Firepower Threat Defense Deployment with a Remote FMC
Advertisement
Chapters
Table of Contents
